摘要
An S band SLED-type pulse compressor has been manufactured by the Institute of High Energy Physics,Beijing, trying to reach 100 MW maximum input power, which means the output peak power is about 500 MW at the phase reversal time. To improve the reliability at very high power, amplitude modulation and phase modulation with flat-top output are considered, and RF modulation studies on the S-band SLED are presented in this paper.Furthermore, a method is developed using the CST Microwave Studio transient solver to simulate the time response of the pulse compressor, which can verify the modulation theory. In addition, the experimental setup was constructed and the flat-top output obtained in low power tests. Both amplitude modulation and phase modulation methods can give flat-top output, and the average power gain for both methods is almost the same.
An S band SLED-type pulse compressor has been manufactured by the Institute of High Energy Physics,Beijing, trying to reach 100 MW maximum input power, which means the output peak power is about 500 MW at the phase reversal time. To improve the reliability at very high power, amplitude modulation and phase modulation with flat-top output are considered, and RF modulation studies on the S-band SLED are presented in this paper.Furthermore, a method is developed using the CST Microwave Studio transient solver to simulate the time response of the pulse compressor, which can verify the modulation theory. In addition, the experimental setup was constructed and the flat-top output obtained in low power tests. Both amplitude modulation and phase modulation methods can give flat-top output, and the average power gain for both methods is almost the same.
基金
Supported by National Natural Science Foundation of China(11475201)
