摘要
An innovative method called semi-continuous equal channel angular extrusion （SC-ECAE） has been devel- oped to produce ullrafine grained steel by inducing severe plastic deformation. In contrast to the external forces that are exerted on specimens in traditional ECAE, the driving forces are applied on the dies in the novel SC EACE process. Commercial interslitial-free steel sheets with width of 160 mm and tbickness of 2 mm were processed re peatedly to various passes at room temperature using this method. The microstructural evolution was characterized using high-resolution electron backscatter diffraction （EBSD）, and the mechanical properties were investigated by tensile testing. The EBSD images indicated that the fraction of high angle boundaries （HABs） began to increase gradually after four passes; after six passes, elongated HAB structures with nearly submicron-scale average spacings were formed. The tensile testing results showed that strengthening was accompanied by a decrease in tensile ductili- ly, but no significant anisotropy was observed. After 10 passes, a final HAB fraction of about 90% and an overall grain size of 0.55 μm, yield strength of 638.7 MPa, an ultimate tensile strength （UTS） of 710.3 MPa, and a totfd elongation of 12.0 % were obtained.
An innovative method called semi-continuous equal channel angular extrusion （SC-ECAE） has been devel- oped to produce ullrafine grained steel by inducing severe plastic deformation. In contrast to the external forces that are exerted on specimens in traditional ECAE, the driving forces are applied on the dies in the novel SC EACE process. Commercial interslitial-free steel sheets with width of 160 mm and tbickness of 2 mm were processed re peatedly to various passes at room temperature using this method. The microstructural evolution was characterized using high-resolution electron backscatter diffraction （EBSD）, and the mechanical properties were investigated by tensile testing. The EBSD images indicated that the fraction of high angle boundaries （HABs） began to increase gradually after four passes; after six passes, elongated HAB structures with nearly submicron-scale average spacings were formed. The tensile testing results showed that strengthening was accompanied by a decrease in tensile ductili- ly, but no significant anisotropy was observed. After 10 passes, a final HAB fraction of about 90% and an overall grain size of 0.55 μm, yield strength of 638.7 MPa, an ultimate tensile strength （UTS） of 710.3 MPa, and a totfd elongation of 12.0 % were obtained.
