摘要
采用Air和CO_2作为供料和输送载气,以工业级竖直上升管(内径50 mm)粉煤输送系统为实验平台,开展了粉煤密相气力输送实验研究。实验中选用Air→Air、Air→CO_2、CO_2→Air和CO_2→CO_2作为典型工况,进行了输送特性参数的对比分析。研究结果表明,供料载气与输送载气组合方式的变化,会引起发料罐中粉煤流化状态的改变,进而导致粉煤输送流型和稳定性方面的差异。借助电容层析成像系统(ECT)获得了竖直管的ECT信号和流型图像,并采用标准差和功率谱函数对ECT信号进行分析。分析结果表明,Air→Air工况为稳定的环状流;Air→CO_2输送过程稳定性最差,输送由无定态流型转为栓塞流;CO_2→Air和CO_2→CO_2输送过程均为气栓流,但CO_2→CO_2工况形成的气栓较长,其ECT信号的功率谱峰值较大。
The dense-phase pneumatic conveying of pulverized coal was investigated in an industrial-scale vertical pipe(50 mm I.D.). Air and CO2 was used as feeding gas or carrying gas, which consequently forms four typical cases, namely Air→Air, Air→CO2, CO2→Air and CO2→CO2. Comparison was conducted between the above cases to analyze the conveying characteristics of pulverized coal experienced different courses. The results showed that the compound modes of feeding gas and carrying gas could affect the fluidized state of pulverized coal in the feeder vessel and result in the differences of stability and flow patterns of conveying process. Electrical capacitance tomography(ECT) was employed to monitor the flow patterns, while the solid concentration signals obtained from ECT were analyzed on the basis of standard deviation(SD) function and power spectral density(PSD) function. It was concluded that the flow pattern of pulverized coal in the case of Air→Air was a stable annular flow, and the stability of the case of Air→CO2 was the worst in which the flow pattern changed from a stable flow to slug flow. Both cases of CO2→Air and CO2→CO2 performed plug flow. In comparison, in the case of CO2→CO2, the bigger plug and higher peak value of PSD were obtained.
出处
《化工学报》
EI
CAS
CSCD
北大核心
2016年第4期1169-1178,共10页
CIESC Journal
基金
国家自然科学基金项目(21206041)~~