期刊文献+

高速气流静压润滑进口压力损失理论与实验研究 被引量:1

Experimental and Theoretical Analyses of Entrance Pressure Loss of High Speed Airflow of Hydrostatic Lubrication
下载PDF
导出
摘要 考虑进口压力损失和阻塞流效应, 建立高速气流静压润滑进口压力损失数学模型, 并对间隙压力分布进行理论分析和实验研究.结果表明: 随着密封间隙增加, 进口压力损失增大, 当雷诺数达到104~106 时, 压力损失迅速增加, 之后趋于稳定; 随操作压差增加, 进口压力损失逐渐增强后维持定值; 理论与实验结果对比分析表明, 湍流状态进口压力修正方程适用于高速气流进口压力损失的求解. Based on the correction equation about entrance pressure loss and Reynolds equation with the chocked flow,a theoretical model of high speed airflow of hydrostatic lubrication was built to analyze the entrance pressure loss,which was proven by an experiment. Results show that the enhance pressure loss has significant influence on pressure distribution. With the increasing clearance,the pressure loss is enhanced first slowly,then increased significantly while the value of Reynolds number is between 104 and 106,and kept unchanged finally. The entrance pressure loss is enhanced with the increasing operating pressure,then kept constant. Results of the experiments are consistent with that of the theoretical analysis,which verifies that the correction equation of turbulent regime can be applied to investigate the pressure distribution of high speed airflow of hydrostatic lubrication.
出处 《润滑与密封》 CAS CSCD 北大核心 2016年第5期34-38,共5页 Lubrication Engineering
基金 国家自然科学基金项目(51275473) 浙江省自然科学基金杰出青年基金项目(LR14E050001)
关键词 高速气流 进口压力损失 压力分布 阻塞流 high speed airflow entrance pressure loss pressure distribution chocked flow
  • 相关文献

参考文献15

  • 1SAFFARI H,MOOSAVI R,NOURIE N M,et al.Prediction ofhydrodynamic entrance length for single and two-phase flow inhelical coils[J].Chemical Engineering and Processing(ProcessIntensification),2014,86:9-21.
  • 2JAWORSKI A,MAO X A,MAO X R,et al.Entrance effect inthe channels of the parallel plate stack in oscillatory flow condi-tions[J].Experimental Thermal and Fluid Science,2009,33:495-502.
  • 3丁少鹏,白少先.深槽表面气体静压润滑低Reynolds数层流节流效应实验研究[J].摩擦学学报,2015,35(3):249-253. 被引量:1
  • 4MIGLIORINI P,UNTAROIU A,WOOD H,et al.A computation-al fluid dynamics/ bulk-flow hybrid method for determining ro-tordynamic coefficients of annular gas seals[J].Journal of Tri-bology,2012,134(2):390-392.
  • 5VANNARSDAL M,CHILDS D.Static and rotordynamic charac-teristics for a new hole-pattern annular gas seal design incorpo-rating larger diameter holes[J].Journal of Engineering for GasTurbines and Power,2014,136(2):759-767.
  • 6CHILDS D,ARTHUR S,MEHTA N.The impact of hole depthon the rotordynamic and leakage characteristics of hole-pattern-stator gas annular seals[J].Journal of Engineering for Gas Tur-bines and Power,2014,136(4): 042501-6.
  • 7崔殿乐,白少先,孟祥铠,彭旭东.深槽表面涡流效应对气体润滑流量特性的影响[J].润滑与密封,2012,37(11):17-21. 被引量:2
  • 8KAZI S,DUFFY G,CHEN X D.Study of the effect of entrancelength on heat transfer to fibre suspensions in annular flow heatexchangers[J].International Journal of Heat and Mass Transfer,2014,78:548-556.
  • 9GULHANE N,MAHULIKAR S.Variations in gas properties inlaminar micro-convection with entrance effect [J].InternationalJournal of Heat and Mass Transfer,2009,52:1980-1990.
  • 10ZUK J.Analysis of face deformation effects on gas film sealperformance[J].ASLE Transactions,1972,16(4):267-275.

二级参考文献22

  • 1叶小强,何立东,霍耿磊.蜂窝密封流场和泄漏特性的实验研究[J].润滑与密封,2006,31(4):95-97. 被引量:12
  • 2何立东,叶小强,霍耿磊.叶尖密封流场的细观特性对叶轮机械性能的影响[J].润滑与密封,2006,31(4):171-174. 被引量:7
  • 3Childs D, Elrod D, Hale K. Annular honeycomb seals:Test re- sults for leakage and rotordynamic coefficients;Comparisons to labyrinth and smooth configurations[ J]. ASME J Tribol, 1989, 111(4) :293 -300.
  • 4Li Jun, Kong Shengru, Yan Xin, et al. Numerical investigations on leakage performance of the rotating labyrinth honeycomb seal [ J ]. ASME J Eng Gas Turbines Power, 2010, 132 ( 6 ) : 062501.
  • 5Untarolu A, Houston G, Migliorini P, et al. Hole-pattern seals :A three dimensional CFD approach for computing rotordynamic coefficient and leakage characteristics [ C ]//Proceeding of 2009 ASME International Mechanical Engineering Congress and Exposition, Florida, 2010 : 981 - 990.
  • 6Sahlin F, Glavatskih S B, Almqvist T, et al. Two-dimensional CFD-analysis of micro-patterned surfaces in hydrodynamic lu- brication [ J ]. ASME J Tribol, 2005,127:96 - 102.
  • 7Arghir M, Roucou N, Helene M, et al. Theoretical analysis of the incompressible laminar flow in a macro-roughness cell[ J ]. ASME J Tribol,2003,125 : 309 - 318.
  • 8Guardino C, Chew J W, Hills N J. Calculation of surface rough- ness effects on air-riding seals [ J ]. ASME J Eng Gas Turbines Power,2006,126 ( 1 ) :75 - 82.
  • 9Bai Shaoxian, Peng Xudong, Li Yefeng. Gas lubrication analy- sis method of step-dimpled face mechanical seals [ J ]. ASME J Tribo1,2012,134:011702.
  • 10Weatherwax M;Childs D W.Theory versus experiment for the rotordynamic characteristics of a high pressure honeycomb annular gas seal at eccentric positions,2003(02).

共引文献25

同被引文献12

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部