摘要
目的:优选香连金黄软膏的提取工艺和成型工艺。方法:采用单因素多水平试验优选挥发油提取和成型工艺条件;采用正交试验优选醇提和水提工艺条件。结果:挥发油提取工艺为姜黄粉碎至10目,加8倍量水提取5小时;醇提工艺为加8倍量70%乙醇回流提取3次,每次60分钟;水提工艺为加10倍量水提取2次,每次60分钟;成型工艺为水相和油相分别加热至90±2℃,将油相缓缓加到水相中,按同一方向搅拌至冷凝。结论:优选得到的新制备工艺合理、稳定、可行。
Objective: The purpose of this study was to optimize the extraction and molding process of Xianglian Jinhuang Ointment. Methods: By using single factor and multiple level test to optimize the extraction and forming conditions of volatile oil;optimizing the alcohol extraction and water extraction process conditions by orthogonal test. Results: The volatile oil extraction process was crushed Curcuma longa L. to 10 mesh,extracted 5hours with 8times amount of water; alcohol extracted 3times with8 times amount of 70% alcohol and for 60 minutes per time; and the water extraction process was extracted 2times with 10 times amount of water and for 60 minutes per time; in molding process water and oil phase were heated up to 90 ± 2℃,then the oil phase was slowly added to the water and stirred in the same direction to condense. Conclusion: The optimum new extraction condition is stable and feasible.
出处
《四川中医》
2016年第4期121-123,共3页
Journal of Sichuan of Traditional Chinese Medicine
基金
成都中医药大学附属医院2011年度院科研基金资助项目(编号:2011-D-YY-14)
四川省科学技术厅2014年科技支撑计划项目(编号:CKY2014007)
关键词
香连金黄软膏
挥发油提取工艺
醇提工艺
水提工艺
成型工艺
Xianglian Jinhuang Ointment
Volatile oil extraction
Alcohol extraction
Water extraction
Molding process