摘要
分析了带钢连续处理机组中带钢焊缝通过出口段月牙剪和切边剪区域时的速度控制模式,根据机组需要、月牙剪和切边剪投入状况,以及前后带钢宽窄变化等条件,研究了几种典型的速度模式,计算了不同的准确停车位置,为自动控制提供了可靠的数学模型和计算公式。
The strip speed control mode of continuous processing line was analyzed when the strip welding seam passing through side notcher and side trimmer of line exit section. At different kinds of condition including the side notcher and side trimmer being put into service or not, strip width changing before and after the side notcher, some typical speed modes were studied, and the exact strip stop positions were figured out. These speed modes and position formulas were reliable for automation control.
出处
《轧钢》
2016年第2期63-66,共4页
Steel Rolling
关键词
带钢连续处理机组
焊缝
月牙剪
切边剪
速度模式
停车位置
带钢宽度差
continuous strip processing line
welding seam
side notcher
side trimmer
speed mode
stop position
strip widthdifference