期刊文献+

基于重复滑模观测器的直线电机系统干扰估计

Repetitive sliding mode observer for disturbance estimation of a linear motor system
原文传递
导出
摘要 采用常规滑模观测器(SMO)进行干扰估计时,对时变干扰无法实现无静差跟踪,并且估计信号存在抖振。针对一种重复运动直线电机系统,同时存在周期性和非周期性干扰,该文提出一种重复滑模观测器(R-SMO),能够有效克服常规SMO的不足。它将周期性干扰的动力学模型(即内模)引入到观测器中,能够渐近收敛于周期性干扰;而滑模切换项只需针对非周期性干扰进行设计,可以大幅度削减抖振。该文给出了R-SMO的渐近收敛性证明。实验结果表明:R-SMO能够有效地估计出直线电机系统的干扰,用于前馈补偿后提高了跟踪精度,并且在收敛精度和抑制抖振方面均优于常规SMO。该方法还可以扩展到多周期干扰系统和非重复运动领域。 The drawback of the conventional sliding mode observer(SMO)when used for disturbance estimation is that it leads to nonzero estimation errors for a time-varying disturbance and chattering.A repetitive SMO(R-SMO)is developed for a repetitive linear motor system where periodic and non-periodic disturbances exist at the same time,which overcomes the drawback of the conventional SMO.The R-SMO incorporates the internal mode of the periodic disturbance to achieve asymptotic convergence to the periodic disturbance.The switching term then only needs to estimate the non-periodic disturbance which significantly reduces the chattering.The R-SMO is shown to be asymptotically convergent.Tests show that the R-SMO well estimates the disturbances of a linear motor system, improves the tracking accuracy after feedforward compensation and is superior to the conventional SMO in terms of convergence accuracy and chattering.Extensions to systems with multiple periodic disturbances and non-repetitive systems are discussed.
出处 《清华大学学报(自然科学版)》 EI CAS CSCD 北大核心 2016年第6期626-632,共7页 Journal of Tsinghua University(Science and Technology)
基金 国家科技支撑项目(2015BAI03B00) 北京市科技计划项目(Z141100000514015) 清华大学摩擦学国家重点实验室基金项目(SKLT12A03)
关键词 滑模观测器 重复运动 周期性干扰 直线电机 sliding mode observer repetitive motion periodic disturbance linear motor
  • 相关文献

参考文献20

  • 1Lin C,Yau H,Tian Y.Identification and compensation of nonlinear friction characteristics and precision control for a linear motor stage[J].IEEE/ASME Transactions on Mechatronics,2013,18(4):1385-1396.
  • 2李庆雷,王先逵,吴丹,刘成颖,石忠东.永磁同步直线电机推力波动分析及改善措施[J].清华大学学报(自然科学版),2000,40(5):33-36. 被引量:93
  • 3Fujita T,Matsubara A,Yamazaki K.Experimental characterization of disturbance force in a linear drive system with high-precision rolling guideways[J].International Journal of Machine Tools and Manufacture,2011,51(2):104-111.
  • 4Van Den Braembussche P,Swevers J,Van Brussel H,et al.Accurate tracking control of linear synchronous motor machine tool axes[J].Mechatronics,1996,6(5):507-521.
  • 5LU Shaowu,TANG Xiaoqi,SONG Bao,et al.Identification and compensation of force ripple in PMSLM using a JITL technique[J].Asian Journal of Control,2015,17(5):1559-1568.
  • 6Tan K K,Huang S N,Lee T H.Robust adaptive numerical compensation for friction and force ripple in permanent-magnet linear motors[J].IEEE Transactions on Magnetics,2002,38(1):221-228.
  • 7Yu S,Mishra S,Tomizuka M.On-line force ripple identification and compensation in precision positioning of wafer stages[C]//ASME 2007 International Mechanical Engineering Congress and Exposition.New York,NY,USA:ASME,2008:645-650.
  • 8Chen S,Tan K K,Huang S,et al.Modeling and compensation of ripples and friction in permanent-magnet linear motor using a hysteretic relay[J].IEEE/ASME Transactions on Mechatronics,2010,13(4):586-594.
  • 9Wu W C,Liu T S.Sliding mode based learning control for track-following in hard disk drives[J].Mechatronics,2004,14(8):861-876.
  • 10Vinodh K E,Jerome J,Ayyappan S.Comparison of four state observer design algorithms for MIMO system[J].Archives of Control Sciences,2013,23(2):243-256.

二级参考文献1

  • 1Hung Y J,IEEE IECON’92,1992年,2期,459页

共引文献92

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部