摘要
Mechanical quality factor Qm is a key characteristic parameter of High-overtone bulk acoustic resonator(HBAR). The effects of structure parameter(thickness) and perfor?mance parameters(characteristic impedance and mechanical attenuation factor) of substrate,piezoelectric film and electrode constituting HBAR on Qm are carried out. The relationships between Qm and these parameters are obtained by a lumped parameter equivalent circuit instead of distributed parameter equivalent circuit near the resonance frequency, and the an?alytical expressions oi Qm are given. The results show that Qm increases non-monotonically with the continuous increase of the substrate thickness for HBAR with certain piezoelectric film thickness, and it approaches to the substrate material mechanical quality factor as the substrate thickness is large. Qm decreases wavily with the continuous increase of the piezoelectric film thickness for HBAR with certain substrate thickness. Sapphire and YAG with low mechanical loss are appropriate as the substrate to get a larger Qm- The electrode loss must be considered since it can reduce Qm- Compared with Au electrode, A1 electrode with lower loss can obtain higher Qm when the appropriate electrode thickness is selected. In addition, Qm decreases with the increase of frequency. These results provide the theoretical basis for optimizing the parameters of HBAR and show that trade-oflFs between Qm and must be considered in the design because their changes are often inconsistent.
Mechanical quality factor Qm is a key characteristic parameter of High-overtone bulk acoustic resonator(HBAR). The effects of structure parameter(thickness) and perfor?mance parameters(characteristic impedance and mechanical attenuation factor) of substrate,piezoelectric film and electrode constituting HBAR on Qm are carried out. The relationships between Qm and these parameters are obtained by a lumped parameter equivalent circuit instead of distributed parameter equivalent circuit near the resonance frequency, and the an?alytical expressions oi Qm are given. The results show that Qm increases non-monotonically with the continuous increase of the substrate thickness for HBAR with certain piezoelectric film thickness, and it approaches to the substrate material mechanical quality factor as the substrate thickness is large. Qm decreases wavily with the continuous increase of the piezoelectric film thickness for HBAR with certain substrate thickness. Sapphire and YAG with low mechanical loss are appropriate as the substrate to get a larger Qm- The electrode loss must be considered since it can reduce Qm- Compared with Au electrode, A1 electrode with lower loss can obtain higher Qm when the appropriate electrode thickness is selected. In addition, Qm decreases with the increase of frequency. These results provide the theoretical basis for optimizing the parameters of HBAR and show that trade-oflFs between Qm and must be considered in the design because their changes are often inconsistent.
基金
supported by the National Natural Science Foundation of China(11374327)