摘要
采用对比实验法,使用S30T硬质合金刀具对钛合金进行高速干式铣削,研究了在正常磨损阶段,主要铣削参数改变时刀具磨损对表面粗糙度的影响。结果表明:高速铣削钛合金时可得到较小的表面粗糙度值;铣削速度增加时,随刀具磨损的增大表面粗糙度值呈减小的趋势;铣削深度增大时,随刀具磨损的增大表面粗糙度值呈增大的趋势;每齿进给量增大时,随刀具磨损的增大表面粗糙度值呈先增大后趋向平稳的趋势。
Abstract, Keywords S30T carbide cutting tools was used for high speed dry milling of titanium alloy by contrast experiment method, study the influence of tool wear on surface roughness when the main milling parameters changed in normal wear stage. The results show that ： high speed milling of titanium alloy can get smaller surface roughness; the surface roughness decreases along with the increase of tool wear trend when the milling speed increases; when the milling depth increase, the surface roughness shows a trend of increasing along with the increase of tool wear; with the increase of tool wear, when the feed per tooth increases, the surface roughness becomes smooth after the first increasing trend. ： titanium alloy ; high speed milling; milling parameters ; tool wear; surface roughness
出处
《制造技术与机床》
北大核心
2016年第10期126-128,142,共4页
Manufacturing Technology & Machine Tool
基金
国家科技重大专项(2012ZX04003-061)
关键词
钛合金
高速铣削
铣削参数
刀具磨损
表面粗糙度
S30T carbide cutting tools was used for high speed dry milling of titanium alloy by contrast experiment method, study the influence of tool wear on surface roughness when the main milling parameters changed in normal wear stage. The results show that ： high speed milling of titanium alloy can get smaller surface roughness
the surface roughness decreases along with the increase of tool wear trend when the milling speed increases
when the milling depth increase, the surface roughness shows a trend of increasing along with the increase of tool wear
with the increase of tool wear, when the feed per tooth increases, the surface roughness becomes smooth after the first increasing trend. ： titanium alloy
high speed milling
milling parameters
tool wear
surface roughness
