期刊文献+

喷油器装配线生产效率提升分析 被引量:2

Analysis on development of efficiency of fuel injector assembly line
下载PDF
导出
摘要 目前的喷油器装配线虽然有很高的生产效率,但是一条生产线上各个工位的生产时间相差较大,导致整条装配生产线的效率难以提高,造成机器设备生产能力的浪费和人力资源的浪费。文章采用MTM-1方法对RB公司装配线瓶颈工序进行了动作分析,得出了瓶颈工序的时值分析表,并根据分析结果对该工序进行了改善,将瓶颈工位的操作时间减少了10.3%,整条生产线的生产时间更为平衡。 Although current manufacturing line of fuel injector is very efficient, the production time of every location on a production line different a lot, which makes it hard to improve the efficiency of the whole manufacturing line and wastes the production capacity of equipment and human resource. This article uses the method of MTM-1, analyzes the assembly line bottleneck process in action on RB, then concludes the bottleneck process value analysis table, and improves the process according to the results of the analysis,the working time was reduced by 10.3%, and the production time on assembly line was more balanced.
作者 周振纲 Zhou Zhengang(School of Mechanical Engineering, Shanghai Jiaotong University, Shanghai 200030, Chin)
出处 《江苏科技信息》 2016年第27期74-77,共4页 Jiangsu Science and Technology Information
关键词 喷油器 装配线 MTM-1 fuel injector assembly line MTM-1
  • 引文网络
  • 相关文献

参考文献1

二级参考文献8

  • 1何善平,奚立峰.发动机装配线平衡方法研究[J].工业工程,2005,8(3):83-88. 被引量:24
  • 2范中志.工业工程基础[M].广州:南华理工大学出版社,2005,210-230.
  • 3诺伊.人力资源管理基础[M].北京:中国人民大学出版社,2005,198-209.
  • 4Andris freivalds,Benjamin W.Niebel.方法标准与作业设计[M].北京:清华大学出版社,2007:411-420.
  • 5Delmar W.Karger-Franklin H.Bayha.Engineered work measurement: the principles, techniques, and data of methods-time measurement background and foundations of work measurement and methods-time measurement, plus other related material[M].New York : Industrial Press, 1986: 3-18.
  • 6Harold B.Maynard, Stegemerten John L, Schwab. Methods -time measurement[M].New York : McGraw-Hill Book Co, 1948 : 278-292.
  • 7尹聚亮,王效俐,王艺.基于MTM法轿车总装线生产线平衡分析与改善[C].管理科学与工程学会.2008中国管理科学与工程发展报告.北京:中国科学技术出版社,2008:23-26.
  • 8张明.MTM在汽车总装车间生产线布线中的应用[J].汽车维修,2008(12):22-23. 被引量:10

共引文献13

同被引文献14

引证文献2

二级引证文献5

;
使用帮助 返回顶部