期刊文献+

二维超声波风速风向传感器风向信号修正方法 被引量:2

Correction method for wind direction signal measured by 2D ultrasonic anemometer
下载PDF
导出
摘要 针对二维超声波风速风向传感器输出的风向信号普遍存在风向角瞬变的问题,研究了产生风向角瞬变现象的原因,并提出了一种基于幅值—符号分解的风向修正算法。理论分析和实验结果表明:风向信号中的风向角瞬变是由传感器的量程限制造成的;基于幅值—符号分解的风向修正算法能在不改变风向角所表征的方位特征的前提下消除风向角瞬变。 Aiming at problem that wind angle transient is common in wind signal for 2D ultrasonic anemometer,causes of this problem is studied,and a correction algorithm based on magnitude / sign decomposition is proposed.Theoretical analysis and experimental results show that the wind angle transient is arised by range limits of sensor,and the correction algorithm based on magnitude / sign decomposition can eliminate this problem without changing orientative feature represented by wind angle.
出处 《传感器与微系统》 CSCD 2016年第11期12-14,22,共4页 Transducer and Microsystem Technologies
基金 国家自然科学基金资助项目(61271321 61573253 61401303)
关键词 风向信号 二维超声波风速风向传感器 幅值—符号分解 风向修正 wind direction signal 2D ultrasonic anemometer magnitude-sign decomposition wind direction correction
  • 相关文献

参考文献2

二级参考文献7

  • 1Daniele Marioli.Digital time-of-flight measurement for ultrasonic sensors[J].IEEE Transactions on Instrumentation and Measurement,1992,41(1):93-97.
  • 2Brassier P.High-frequency transducers and correlation method to enhance ultrasonic gas flow metering[J].Flow Measurement and Instrumentation,2001,12:201-211.
  • 3Roosnek N.Novel digital signal processing techniques for ultrasonic gas flow measurements[J].Flow Measurement and Instrumentation,2000,11:89-99.
  • 4Gueuning F E.Accurate distance measurement by an autonomous ultrasonic system combining time-of-flight and phase-shift methods[J].IEEE Trans on Instruments and Measurement,1997,46(6):1236-1240.
  • 5李增志,黄峰,朱福萌,王金刚.超声风速温度仪的误差分析与检定方法研究[J].气象研究与应用,2009,30(1):58-59. 被引量:9
  • 6王葵军,谢扩军.基于时差法超声波风速风向传感器误差的分析[J].中国电子商情(通信市场),2010(1):17-21. 被引量:4
  • 7樊秀云,袁嗣杰,张合敏.伪码数字相关在超声波测距中的应用[J].装备指挥技术学院学报,2002,13(3):77-80. 被引量:17

共引文献13

同被引文献22

引证文献2

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部