摘要
HD1080A-1T低压模块在装配过程中,其上下半垂直法兰面的锥销孔是在缸体接配好之后进行配钻,由于条件的制约,万向摇臂钻无法完全满足要求。通过几种加工方法的分析对比,提出了以液压磁力钻配合相应工装的方法解决了生产中的难题,并在实践中得到了应用。
In the assembly process of HD1080A-1T nuclear power low-voltage module, the upper and lower half of the vertical flange of the cone in the cylinder pin hole is connected with a good distribution after the drill. As conditions set, universal radial drilling cannot fully meet the requirements. Through analysis and comparison of several processing methods, the production problems have been solved by matching the hydraulic magnetic drill and tooling methods, and these methods have been applied in practice.
出处
《装备制造技术》
2016年第10期95-98,共4页
Equipment Manufacturing Technology
关键词
核电
万向摇臂钻
风钻
液压磁力钻
工装设计
nuclear power
universal radial drilling
pneumatic drill
hydraulic magnetic drill
tooling design