摘要
Al2O3 dispersion copper alloy powder was prepared by intemal oxidation, and three consolidation methods--high-velocity compaction （HVC）, hot pressing （HP）, and hot extrusion （HE）--were used to prepare Al2O3 dispersion-strengthened copper （Cu-Al2O3） alloys. The microstructures and properties of these alloys were investigated and compared. The results show that the alloys prepared by the HP and HE methods exhibited the coarsest and finest grain sizes, respectively. The alloy prepared by the HVC method exhibited the lowest relative density （98.3% vs. 99.5% for HP and 100% for HE）, which resulted in the lowest electrical conductivity （81% IACS vs. 86% IACS for HP and 87% IACS for HE）. However, this alloy also exhibited the highest hardness （77 HRB vs. 69 HRB for HP and 70 HRB for HE）, the highest compressive strength （443 MPa vs. 386 MPa for I/P and 378 MPa for HE）, and the best hardness retention among the investigated alloys. The results illustrate that the alloy prepared by the HVC method exhibits high softening temperature and good mechanical properties at high temperatures, which imply long service life when used as spot-welding electrodes.
Al2O3 dispersion copper alloy powder was prepared by intemal oxidation, and three consolidation methods--high-velocity compaction （HVC）, hot pressing （HP）, and hot extrusion （HE）--were used to prepare Al2O3 dispersion-strengthened copper （Cu-Al2O3） alloys. The microstructures and properties of these alloys were investigated and compared. The results show that the alloys prepared by the HP and HE methods exhibited the coarsest and finest grain sizes, respectively. The alloy prepared by the HVC method exhibited the lowest relative density （98.3% vs. 99.5% for HP and 100% for HE）, which resulted in the lowest electrical conductivity （81% IACS vs. 86% IACS for HP and 87% IACS for HE）. However, this alloy also exhibited the highest hardness （77 HRB vs. 69 HRB for HP and 70 HRB for HE）, the highest compressive strength （443 MPa vs. 386 MPa for I/P and 378 MPa for HE）, and the best hardness retention among the investigated alloys. The results illustrate that the alloy prepared by the HVC method exhibits high softening temperature and good mechanical properties at high temperatures, which imply long service life when used as spot-welding electrodes.
基金
financially supported by Guangdong Provincial Industrial High-tech Project (No. 2015A010105020)
Guangzhou Science & Technology New Star of Pearl River Project (No. 2012J2200096)
the Open Research Fund of State Key Laboratory of Powder Metallurgy of Central South University
Guangdong Provincial Innovation Ability Construction Project (No. 2016B070701024)
Guangzhou Innovation Platform Construction and Sharing Project (No. 201509010003)
Guangdong Provincial Science & Technology Basic Condition Construction Field Project (No. 2014B030301012)
