摘要
以丙烯酸甲酯、丙烯酸丁酯和甲基丙烯酸、丙烯酰胺为主要原料,过硫酸铵为引发剂,采用十二烷基硫酸钠和OP-10组成复合乳化剂,通过乳液聚合法合成喷水织造用浆料;测试分析了主要单体对浆液黏度、浆料黏附性和吸水性能的影响,并用红外光谱分析了浆料的分子结构。结果表明所合成的喷水织造用浆料的黏附性较好,吸水率、黏度较低,耐水性能较好。
With methyl acrylate, butyl acrylate, methacrylic acid and acrylamide as main material, ammonium persulfate as initiator, twelve alkyl sodium sulfate and OP-IO as composite emulsifier, water jet slurry was synthesized by emulsion polymerization. The effects of main monomers on slurry viscosity, slurry adhesion and water absorption were tested and analyzed. The molecular structure of the slurry was analyzed by infrared spectrum. The results showed that the water jet weaving slurry had good adhesion, low water absorption, low viscosity and good water resistance.
出处
《纺织科技进展》
CAS
2017年第6期5-8,共4页
Progress in Textile Science & Technology
基金
南通大学研究生自主创新项目(FZ201604)
关键词
喷水织机
浆纱浆料
乳液聚合
浆料性能
water jet loom
sizing agent
emulsion polymerization
slurry properties
