摘要
A novel 22MnMoB hot stamping steel was designed. The continuous cooling transformation （CCT） measurement of the 22MnMoB steel showed that the ferrite-bainite microstructure could be obtained at cooling rates lower than 25 ℃/s, and the complete martensite structure required the cooling rate higher than 30 ℃/s. The experiments with non-uniform die temperatures were carried out to obtain tailored properties. The results showed that strength of 1 411 MPa and elon- gation of 6% could be obtained in the hard zone, and strength of 916 MPa and elongation of 9% could be obtained in the soft zone, which can be realized by controlling the die temperature at 400 ℃. The transition zone was found smooth and could be beneficial to reduce the stress concen tration and therefore improve the performance of components.
A novel 22MnMoB hot stamping steel was designed. The continuous cooling transformation （CCT） measurement of the 22MnMoB steel showed that the ferrite-bainite microstructure could be obtained at cooling rates lower than 25 ℃/s, and the complete martensite structure required the cooling rate higher than 30 ℃/s. The experiments with non-uniform die temperatures were carried out to obtain tailored properties. The results showed that strength of 1 411 MPa and elon- gation of 6% could be obtained in the hard zone, and strength of 916 MPa and elongation of 9% could be obtained in the soft zone, which can be realized by controlling the die temperature at 400 ℃. The transition zone was found smooth and could be beneficial to reduce the stress concen tration and therefore improve the performance of components.
基金
financially supported by National Natural Science Foundation of China(Grant No.U1560204)
Fundamental Research Funds for the Central Universities(Grant No.N150705001)
National Key Research and Development Program of China(Grant No.2016YFB0101605)
