期刊文献+

莱钢药芯焊丝冷轧带钢的开发生产

Development and Production of Cold Rolled Strip for Flux Cored Wire in Laiwu Steel
下载PDF
导出
摘要 通过确定合适的化学成分,采用铁水脱硫预处理→120 t顶底复吹转炉熔炼→RH真空脱气处理→LF精炼处理→1500热连轧→酸洗→1500单机架冷轧→退火及平整→入库的工艺流程,开发生产了LGHS药芯焊丝专用冷轧带钢。质量分析表明,成品带钢屈服强度204 MPa,抗拉强度326 MPa,屈强比0.62,A_(50) 46.2%,n值0.24,r值1.55,完全满足用户要求,实现了批量生产。 Through the determination of chemical composition and the technological route: pretreatment of hot metal desulfurization→120 ton top and bottom combined blown converter smelting→RH vacuum degassing process→LF refining treatment→1 500 mm hot continuous rolling→pickling→1 500 mm stand-alone cold rolling→annealing and smoothing→storage, LGHS--the cold roiled strip for flux cored wire was successfully produced. The quality analysis showed that the average yield strength of finished strip is 204 MPa, the average tensile strength is 326 MPa, the yield strength ratio is 0.62, A50 is 46.2%, the work hardening index is 0.24, the plastic strain ratio is 1.55, which fully met the requirements of custom, and the mass production has been realized.
作者 陈豪卫 CHEN Haowei(Laiwu Branch of Shandong Iron and Steel Co., Ltd., Laiwu 271104, China)
出处 《山东冶金》 CAS 2017年第3期1-3,共3页 Shandong Metallurgy
关键词 药芯焊丝用钢 冷轧带钢 成分设计 深冲性能 steel for flux cored wire cold rolled strip composition design deep drawing performance
  • 相关文献

参考文献1

二级参考文献4

  • 1Fukuda M. The Effect of Carbon Content Against r Value-Cold Reductions Relations in Steel Sheets. Iron Steel Inst Jpn, 1967,53:559.
  • 2Yasunobu Nagataki, Yoshihiro Hosoya. Origin of the Recrystallization Texture Formation in an Interstitial Free Steel. ISIJ International, 1996,36(4) :451.
  • 3Christian Klinkenberg,Dierk Raabe,Kurt LOcke. Influence of Volume Fraction and Dispersion Rate of Grain-Boundary Cementite on the Cold-Rolling Textures of Low-Carbon Steel. Steel Research, 1992,63 (6) :263.
  • 4吕庆功,陈光南,周家琮,唐历.深冲钢板的主要织构对塑性应变比的影响[J].钢铁研究,2000,28(5):40-43. 被引量:45

共引文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部