拼装式SMC水池结构有限元分析

Structural finite element analysis of assembled SMC pool

针对现有水泥砂浆抹面或混凝土水池存在施工周期长、维修成本高、防渗性差、难于规模化生产等一系列问题,设计了一种新型拼装式SMC(sheet molding compound)水池结构,并利用ANSYS软件建立了水池的有限元模型,分析了水池结构的应力和变形情况.运用电测技术对其进行试验分析,证实了有限元模型的合理性,在此基础上,分析了水池结构在空载、满载等不同工况下强度和刚度的变化规律.研究结果表明,新型水池能够满足设计要求.

Aiming at a series of problems of the existing cement mortar or concrete pool such as long construction period, high maintenance cost, poor anti-seepage and difficult to scale production etc, a new type of assembled SMC pool is designed. For studying the structural characteristics of the pool, a finite element model of the pool is established by using ANSYS software, and the stress and deformation of the s cal measurement tec the finite element m ness is analyzed meet the design und tructure are obtained. The experimental data which are acquired by the electrihnique are compared with the simulation results. It confirms the rationality of odel. On the basis of this,the influence rule of the structural strength and stiffer the condition of no-load and full load, and the results show that the pool can requirements,