摘要
利用有限元法,对某电厂一台高压加热器的球壳接管结构进行了极限载荷分析。采用理想弹塑性材料模型,基于小变形假设,通过弹塑性增量有限元分析,得到了球壳接管结构的塑性极限载荷。最后,根据JB4732标准对该结构进行评定。结果表明,该球壳接管结构满足强度要求。
In this paper,limit load analysis method based on FEA is used for a nozzle of a high pressure heater.Limit load of the nozzle is obtained by FEA,based on elastic-perfectly plastic and the assumption of small deformation. Finally,the intensity of the nozzle is checked based on JB4732. The result shows that the nozzle meet the requirement of intensity.
出处
《装备制造技术》
2017年第6期164-165,173,共3页
Equipment Manufacturing Technology
基金
湖南省教育厅科学研究一般项目(16C1173
14C0767)
