摘要
采用MAG焊在对接接头形式下,分别选用二元保护气体(Ar+O2)和不同比例的三元保护气体(Ar+CO2+O2),在4mm厚的304不锈钢板上进行焊接工艺试验。焊后观察并测量焊接接头,比较不同保护气体下的焊缝外观成形质量,测量焊缝合金元素及氧的含量,并测试了焊接接头的硬度、拉伸、弯曲以及低温冲击性能。
The welding technology experiment is conduced on a 4 mm 304 stainless steel by MAG welding respectively with binary hybrid gas (Ar+O2) and different proportional ternary mixture gas (Ar+CO2+O2). By observing and measuring the welded joints after welding, the quality of weld appearance obtained in different shielded gases are compared ,the alloy elements and oxygen content of the welds are measured, and the hardness, tensile, bending and low-temperature impact of the welded joints are also measured.
出处
《电焊机》
2017年第7期73-77,共5页
Electric Welding Machine
关键词
304不锈钢
MAG焊
三元保护气体
焊接工艺
组织与性能
304 stainless steel
MAG welding
ternary hybrid shielded gas
welding technology
microstructure and property