期刊文献+

U型双金属复合翅片换热管振动模态分析 被引量:3

ANALYSIS ON VIBRATION MODAL OF U-BIMETALLIC FINNED TUBES
下载PDF
导出
摘要 双金属复合翅片管是国内外广泛使用的一种新型换热元件。为了对U型双金属复合翅片换热管的流体诱导振动破坏进行预测和控制,需要对其振动模态进行准确分析。采用锤击法和有限元法对U型钢-铝双金属复合翅片管的面内、面外振动模态进行了实验测试和数值模拟,并分析了U型管圆弧弯管半径R对其固有频率的影响特性。在自由支撑条件下,U型钢-铝双金属复合翅片管固有频率的有限元分析值与实测值相比,前18阶频率的最大误差为7.3%。在固支-简支条件下,U型钢-铝双金属翅片管的各阶固有频率均随着圆弧弯管半径R的增大而减小。 U-bimetallic finned tube is a new widely used heat exchange component.In order to predict and control the flowinduced vibration damage of U-bimetallic finned heat exchange tubes,their natural frequencies must be calculated accurately.Inplane and out-of-plane vibration modal of U-bimetallic finned tubes were investigated by means of the hammering method and finite element method.The influence of arc bending radius R of U-bimetallic finned tubes on their natural frequencies was analyzed.The finite element simulation results of natural frequencies of U-bimetallic finned tubes were compared with the measured values for free-free boundary condition,the maximum error of the first 18 order frequencies is 7.3%.The natural frequencies of U-bimetallic finned tubes decrease with increasing the arc radius R for clamped-hinged case.
出处 《机械强度》 CAS CSCD 北大核心 2017年第4期787-791,共5页 Journal of Mechanical Strength
基金 山西省自然科学基金项目(2013011025-2) 山西省研究生教育改革研究课题(2016JG40)资助~~
关键词 U型双金属翅片管 振动模态 锤击法 有限元法 U-bimetallic finned tubes Vibration modal Hammering method Finite element method
  • 相关文献

参考文献5

二级参考文献16

  • 1王学生,李培宁,王如竹,许煜雄.双金属复合管液压成形压力的计算[J].机械强度,2002,24(3):439-442. 被引量:22
  • 2庄茁,张帆,岑松.ABAQUS非线性有限元分析与实例[M].北京:科学出版社,2008.
  • 3Chen S S,J Pressure Vessel Technol,1985年,107卷
  • 4伊传家,振动工程大全.上(译),1983年
  • 5胡人礼,工程中的振动问题(译),1978年
  • 6钱颂文,换热器流体诱导振动,1988年
  • 7Mark A Spence, Ces V Roscoe. Bi-mtal CRA-lined pipe employed, for north sea field development. Oil & Gas Journal, 1999, 97(18): 80~ 88.
  • 8Gomez X, Echeberria J. Microstructure and mechanical properties of carbon steel A2102 superaltoy sanicro bimetallic tubes [ J 1. Materials Science and Engineering, 2003, 348(122) : 180-191.
  • 9Alcaraz J L, Gil2Sevillano J. An analysis of the extrusion of bimetallic tubes by numerical simulation [ Jl. International Journal of Mechanical Sciences, 1996, 38 ( 2 ) : 157-173.
  • 10Krips H, Podhorsky M. Hyraolic expansion-a new method for anchoring of tubes [ J ]. Vgb Krapwerks-Tchink, 1976 ( 7 ) : 418- 426.

共引文献29

同被引文献18

引证文献3

二级引证文献6

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部