摘要
介绍了T2纯铜触头座零件的成形工艺和试制过程中各工序的参数检测。采用低温扩孔、冷扩孔和冷旋压等工艺,通过对生产中的温度、硬度、尺寸等的控制,最终满足了零件的成形要求。
The forming process of T2 pure copper contact seat and the parameters inspection of each procedures during the trial-produce were introduced. The process of low temperature ring rolling, cold ring rolling and cold spinning was applied, and the forming requirements of the part were finally fulfilled through the control of temperature, hardness and dimensions in the production.
出处
《热加工工艺》
CSCD
北大核心
2017年第15期134-136,共3页
Hot Working Technology
关键词
扩孔
冷旋压
冷作硬化
纯铜
硬度
ring rolling
cold spinning
cold hardening
pure copper
hardness