仿真软件在汽车电工电子课程教学中的应用

Application of Simulation Software in the Electrical and Electronic Principle Teaching

学生首先通过Visio软件绘制流程图，理清汽车转向信号灯和危险警报灯的逻辑控制方法，其次利用Keil软件编写和编译控制程序，再在Multisim或Proteus仿真软件上设计并绘制电路图，最后加载程序并调试运行。确保每个学生都可以在电脑上进行实操训练，达到掌握电子控制原理的教学目的。

Firstly, the students draw the flow chart with Visio software to have a clear idea of the logic control meth- ods of turning signal lights and danger warning lights ; then write and compile control program with Keil ; next, with simulation software, Muhisim or Proteus, design and draw the circuit diagrams;finally the program is loaded into the circuit diagram and debugged. In practical teaching, to master Electrical and Electronic Principles, each student is sure to participate in the hands -on training on computers.