惯性测量组件标定与测试系统研制

The development of Inertial measurement component calibration and test system

本文设计并研制出能够同时测两个惯测分组件的测控系统,主要用来对捷联惯性测量组件的加速度/角速度脉冲计数、温度和修正常数读取、工作信号发送等,以完成对惯性测量组件的性能测试。本文根据选定的标定方法,给出了系统的总体设计,又分别对系统的硬件设计和软件设计做了具体说明,最后经过测试验证该系统能够满足产品测试性能要求。

This paper designed a measurement and control system that used for strapdown inertial measurement component .It can count acceleration/angular velocity pulse , read temperature and modified constant , and send working signal.The system can complete the test on the performance of the inertial measurement components.According to the selected calibration method, this paper gives the overall design of the system, and respectively on the system of specific instructions to the hardware design and software design, finally tested to verify the system can meet the product performance test requirements.