期刊文献+

表贴式永磁同步电机气隙磁密的计算与分析 被引量:8

Calculation and Analysis of Air Gap Flux Density for Surface Permanent Magnet Synchronous Motor
下载PDF
导出
摘要 永磁电机的气隙磁密决定了电机能量转换的能力,直接影响着电机的工作特性。针对表贴式永磁同步电机,分别应用傅里叶级数展开的计算方法和Ansoft有限元软件,对径向充磁和平行充磁的两种结构,进行了气隙磁密的分析,以及气隙磁密波形和反电动势波形的仿真。通过对比分析可知,理论计算与仿真分析结果非常接近。采用的方法可以准确得出永磁电机的气隙磁密,对表贴式永磁同步电机的优化设计以及电磁特性分析等具有一定的参考价值。 The air gap flux density of the permanent magnet motor determines the energy conversion of the motor, which directly affects the working performance of the motor. In this paper, the air gap flux density of surface mounted permanent magnet synchronous motor was calculated based on Fourier series calculation method and finite element software Ansoft. And then the air gap flux density waveform and back EMF wave form in the radial direction and par- allel magnetization permanent magnet were obtained through Ansoft. Through contrastive analysis, the results are as same as those of calculation results and simulation results. The air gap flux density of permanent magnet motor can be obtained accurately by this method. The analytical field solutions provide a basis for design optimization and analysis of electromagnetic characteristics.
作者 丁鸿昌 刘鲁伟 吕楠 李茂源 DING Hong - chang;LIU Lu - wei;LV Nan;LI Mao - yuan(College of Mechanical and Electronic Engineering, Shandong University of Science and Technology, Qingdao Shandong 266590, Chin)
出处 《计算机仿真》 北大核心 2018年第4期179-183,共5页 Computer Simulation
基金 中国博士后科学基金项目(2015M582112) 山东省重点研发计划项目(2017GGX203005) 青岛市黄岛区科技计划项目(2014-1-106) 青岛市博士后研究人员应用研究项目(01020120520)
关键词 永磁同步电机 气隙磁密 仿真 Permanent magnet synchronous motor Air gap flux density Simulation
  • 相关文献

参考文献4

二级参考文献37

  • 1蒙亮,罗应立,刘晓芳,杨金福,池永斌.汽轮发电机转子铁心表面电磁力分布的实例研究[J].中国电机工程学报,2005,25(1):81-86. 被引量:25
  • 2陈阳生,林友仰.永磁电机气隙磁密的分析计算[J].中国电机工程学报,1994,14(5):17-26. 被引量:44
  • 3李志强,罗应立,蒙亮.基于有限元的虚位移原理在汽轮发电机局部电磁力计算中的应用[J].中国电机工程学报,2007,27(15):47-52. 被引量:16
  • 4Wignall A N, Gilbert A J, Yang S J. Calculation of force on magnetic ferrous cores using the Maxwell stress method[J]. IEEE Trans. on Magnetics, 1988, 4(1): 459-462.
  • 5Ren Z. Comparison of different force calculation methods in 3D finite element modelling[J]. IEEE Trans. on Magnetics, 1994, 30(5): 3471-3474.
  • 6Tarnhuvud T, Reichert K. Accuracy problems of force and torque calculation in FE-systems[J]. IEEE Trans.on Magnetics, 1988, 24(1): 443-446.
  • 7Chang L, Eastham magnet synchrono calculation[C]. Proc. Annual Meetings, S A R, Dawson G E. Permanent us motor:finite element torque IEEE Industry Application Society an Diego, USA, 1989: 69-73.
  • 8Lieven Vandevelde, Melkebeek Jan A A. A survey of magnetic force distributions based on different mag- netization models and on the virtual work principle[J] IEEE Trans. on Magnetics, 2001, 37(5), 3405-3409.
  • 9Muller W. Comparision of different methods of force calculation[J]. IEEE Trans. on Magnetics, 1990, 26(2) 1058-1061.
  • 10Benhama A, Williamson A C, Reece A B J. Virtual work approach to the computation of magnetic force distribution from finite element field solutions[J]. IEE Proc-Electr. Power Appl, 2000, 147(6): 437-442.

共引文献42

同被引文献67

引证文献8

二级引证文献21

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部