摘要
设计一种一体化D-dot探头开展脉冲功率装置中传输线高电压测量工作。D-dot探头安装在传输线外筒上,主要由基座、密封电缆头、探头外壳、绝缘层、信号电极和连接杆构成。采用同轴螺纹连接及限位结构将探头各部件形成一个整体,实现结构的紧凑性和拆装过程的完整性。利用密封BNC探头和无氧铜密封圈实现良好的密封性能,同时减小探头的弹性余量保证测量的准确性。设计了较小的探头对地电容,从而获得良好的高频响应。采用OrCAD/Pspice开展电路模拟,结果显示设计的探头满足信噪比和前沿响应要求。采用CST开展静电场模拟,结果显示设计的D-dot探头可以满足1 MV传输线电压下的绝缘要求。标定和实验结果表明该探头可以响应前沿为几十ns的信号,能够满足测量需要。
An integrative D-dot monitor is designed to measure high voltage pulse in transmission line. The monitor which consists of base, airproof BNC connector, probe shell, insulation, probe and connecting rod is located on the outshell of transmis sion line. Monitor assemblies are coaxially connected by thread, resulting in compaction of configuration and integrality in dis mounting or mounting. An airproof BNC connector and aseal packing ring of oxygen free copper are used to get good sealing per formance and veracity, meanwhile their low elasticity leads to high accuracy of measurement. Low ground capacitance of monitor is designed to get good high frequency response. Simulation by OrCAD/Pspice is taken, with good signal to noise ratio and rising time. Results of simulation on electrostatic field byCST show that the monitor is safe to measure 1 MV high voltage. Results of calibration and experiment show that the integrative D-dot monitor can response to signals with rise time of several tens of nanose conds, which could fulfill our diagnostic requirement.
作者
李春霞
Li Chunxia(Science and Technology on High Power Micro-wave Laboratory,Institute of Applied Electronics,CAEP,Mianyang 621900,China)
出处
《强激光与粒子束》
EI
CAS
CSCD
北大核心
2018年第9期82-85,共4页
High Power Laser and Particle Beams
基金
国家自然科学基金项目(11475158)
关键词
脉冲高压
一体化D-dot探头
脉冲传输线
标定
high voltage pulse
integrative D dot monitor
pulse transmission line
calibration