摘要
湖北汉川某印染园区污水处理厂进水以印染废水为主,水质成分复杂,可生化性差。该污水处理厂现有主体工艺为"混凝初沉+A/O+臭氧氧化",现针对该工艺出水水质不达标的问题,对其进行升级改造,将高级氧化段的臭氧氧化替换为类Fenton氧化。工程实践表明,改造后的工艺运行稳定可靠,出水COD、SS、色度满足《城镇污水处理厂污染物排放标准》(GB 18918—2002)一级A排放标准。
The influent of the wastewater treatment plant of a printing and dyeing park,Hanchuan,Hubei Province,China,has mainly been printing and dyeing wastewater,and the influent characterized by complicated water quality ingredient and poor biodegradability. The present principal process of this wastewater treatment plant is ＂Coagulation/Sedimentation＋A/O＋Ozonation＂. Aiming at the problem that the effluent water quality could not reach the standard,the process is now up-graded and modified by substituting Fenton oxidation for the ozonation of advanced oxidation section. The engineering practice shows that the modified process runs stably and reliably. The effluent COD,SS and chroma meet the requirements for the First A Level Discharge Standard Specified in the Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant（GB 18918—2002）.
作者
刘亚琴
倪慧成
蒋素英
谢菁
李俊波
吴智仁
Liu Yaqin;Ni Huicheng;Jiang Suying;Xie Jing;Li Junbo;Wu Zhiren(Academy of Environmental Health and Ecological Security,Jiangsu University,Zhenjiang 212013,China;Jiangsu A TK Environmental Engineering D＆R Institute,Yixing 214214,China)
出处
《工业水处理》
CAS
CSCD
北大核心
2018年第7期99-102,共4页
Industrial Water Treatment
基金
"十二五"国家科技支撑计划项目(2014BAC08B01)
江苏省科技成果转化专项资金项目(BA2015017)
江苏省重点研发计划项目(BE2015620)
关键词
印染废水
混凝
A/O
类FENTON氧化
printing and dyeing wastewater
coagulation
A / O
Fenton-like oxidation
