期刊文献+

脉冲电流测量线圈试验验证平台的研制 被引量:1

Development of Pulse Current Measurement Coil Test Verification Platform
下载PDF
导出
摘要 面向功率半导体器件测试系统内部脉冲电流测量线圈的性能参数验证,采用二阶非振荡电路原理,分析得出了负载电阻、调波电感、储能电容对脉冲电流测量线圈试验验证平台波形的影响规律,研建的脉冲电流测量线圈试验验证平台上升时间2.6μs、下降时间35μs、电流幅度3000A,电流幅度技术指标优于±2%. For the verification of the performance parameters of the pulse current measurement coil inside the power semiconductor device test system,the second-order non-oscillatory circuit principle was used to analyze the influence of the load resistance,the tuning inductance,and the storage capacitor on the waveform of the pulse current measurement coil test verification platform. The pulse current measurement coil built in the test has been tested to verify that the rise time of the platform is 2.6μs,the fall time is 35μs,and the current amplitude is 3000 A.The current amplitude specification is better than ±2%.
作者 常亮 朱望纯 刘冲 CHANG Liang1, ZHU Wang-chun1, LIU Chong2(1.Guilin University Of Electronic Technology, Guilin Guangxi 541004, China; 2. China Electronics Standardization Institute, Beijing 100176, Chin)
出处 《装备制造技术》 2018年第7期223-226,230,共5页 Equipment Manufacturing Technology
关键词 脉冲电流 测量线圈 试验验证平台 Pulse current measuring coil test verification platform
  • 相关文献

参考文献3

二级参考文献6

  • 1任洪林,张玉红.Rogowski线圈仿真的分裂算法[J].高电压技术,2007,33(4):57-60. 被引量:3
  • 2Ray W F.Rogowski transducers for measuring large magnitude short duration pulses[C].IEE Symposium on pulse power,London,UK,2000,(23):164.
  • 3Robles G,Argueso M,Sanz J,et.al.Identification of parameters in a Rogowski coil used for the measurement of partial discharges[C].Instrumentation and measurement Technology Conference,Warsaw,Poland,2007.
  • 4张仁豫,陈昌渔,王昌长.高电压实验技术[M].北京:清华大学出版社,2009.
  • 5Wong C S,Rev Sci Instrum,1985年,56卷,5期,767页
  • 6Liu Chong,Yu Li hong.Research on Amplitude Calibration of High Pulse Current Source of Semiconductor Device Test System[C].IEEE Conference on Electronic Measurement&Instruments.2011:Ⅱ232-235.

共引文献13

同被引文献6

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部