摘要
为了实现对进给方向超声振动辅助铣削加工表面形貌的准确预测,建立了超声振动辅助铣削加工过程数学物理预测模型。为了验证该预测模型对超声振动辅助铣削加工三维表面预测结果的准确性,利用MATLAB软件以此模型为基础进行了进给方向的超声振动辅助铣削表面形貌仿真分析,并进行了切削加工实验。结果表明:通过仿真分析和实验验证,证明了该预测模型的准确性和有效性。
To predict surface topography of feed direction vibration assisted milling accurately,amathematical predictive model was established. Based on the predictive model,surface topographysimulation was analyzed by MATLAB program. Experimental tests were made to verify the results ofsimulation. The results show that the predictive modeling is accurate through simulation analysis andexperimental verification.
作者
刘宪福
张建华
陶国灿
白丽娟
LIU Xianfu;ZHANG Jianhua;TAO Guocan;BAI Lijuan(Key Laboratory of High Efficiency and Clean Mechanical Manufacture,Ministry of Education ofChina,National Demonstration Center for Experimental Mechanical Engineering Education,Shandong University,Jinan 250061,China)
出处
《电加工与模具》
2018年第5期57-60,共4页
Electromachining & Mould
基金
国家自然科学基金资助项目(51475275)
关键词
超声振动辅助铣削
三维表面形貌
预测模型
仿真分析
vibration assisted milling
surface topography
predictive modeling
simulation analysis