摘要
A series of new Cr-Mn-Fe-V-Cu high-entropy alloys were prepared by arc melting and suction casting.It is found that with the addition of Cu, the structure of the alloys evolved from BCC ＋ BCC1 phases to BCC ＋ FCC phases. With increase of Cu, the volume fraction of the Cu-Mn-rich FCC phase increased, and the morphology of the FCC phase transformed from granular particles to long strips and blocks. Compared with other reported HEAs, the Cr-Mn-Fe-V-Cu HEAs exhibit a good balance between strength and ductility. The CrMn0.3 FeVCu0.06 alloy with granular FCC particles exhibits the highest compressive yield strength（1273 MPa） and excellent ductility（εf= 50.7%）. Quantitative calculations for different strengthening mechanisms demonstrate that dislocation and precipitate strengthening are responsible for high strength of the CrMn0.3 FeVCu0.06 alloy, while the solid solution strengthening effect is very low because of its small atomic-size difference. In addition, the CrMn0.3 FeVCu0.06 alloy exhibits good damping capacity due to its high dislocation and interface damping effects. Therefore, the dislocation density and distribution of FCC phase are the crucial factors for improvement of both mechanical properties and damping capacity of the HEAs.
A series of new Cr-Mn-Fe-V-Cu high-entropy alloys were prepared by arc melting and suction casting.It is found that with the addition of Cu, the structure of the alloys evolved from BCC ＋ BCC1 phases to BCC ＋ FCC phases. With increase of Cu, the volume fraction of the Cu-Mn-rich FCC phase increased, and the morphology of the FCC phase transformed from granular particles to long strips and blocks. Compared with other reported HEAs, the Cr-Mn-Fe-V-Cu HEAs exhibit a good balance between strength and ductility. The CrMn0.3 FeVCu0.06 alloy with granular FCC particles exhibits the highest compressive yield strength（1273 MPa） and excellent ductility（εf= 50.7%）. Quantitative calculations for different strengthening mechanisms demonstrate that dislocation and precipitate strengthening are responsible for high strength of the CrMn0.3 FeVCu0.06 alloy, while the solid solution strengthening effect is very low because of its small atomic-size difference. In addition, the CrMn0.3 FeVCu0.06 alloy exhibits good damping capacity due to its high dislocation and interface damping effects. Therefore, the dislocation density and distribution of FCC phase are the crucial factors for improvement of both mechanical properties and damping capacity of the HEAs.
基金
support with testing materials and facilities from the Interdisciplinary Research Center for Advanced Structural and Biomaterials, Beihang University
