期刊文献+

强度匹配对核容器用钢A508-Ⅲ焊接接头断裂行为的影响 被引量:9

Effect of Strength Mis-Matching on Fracture Behavior for Nuclear Pressure Vessel Steel A508-Ⅲ Welded Joints
下载PDF
导出
摘要 针对核容器用钢A5 0 8-Ⅲ接头 ,通过断裂力学试验和有限元数值模拟综合研究强度匹配对接头抗断裂行为的影响 ,尤其是对热影响区断裂行为的影响。结果表明 ,选用高匹配焊缝可降低焊缝裂纹试样的裂尖张开应力和应力三轴度 ,改善焊缝的抗断裂行为 ;而却使热影响区裂纹试样的裂尖张开应力和应力三轴度升高 ,对热影响区的抗断裂行为不利 ,定性地说明了低匹配A5 0 The effect of strength mis matching on the fracture behavior of A508 Ⅲwelded joints was analyzed by fracture mechanics test and FE calculation,the fracture behavior for HAZ was emphasized especially.It has been shown that the opening stress and stress triaxiality in the vicinity of crack tip are reduced for weld crack specimen,and increased for HAZ crack specimen,if the over matching weld is used.In other words,over matching could improve the fracture resistance for weld crack specimen,and deteriorate for HAZ crack specimen.This tendency was confirmed by the test result.
出处 《焊接学报》 EI CAS CSCD 北大核心 2002年第5期35-37,44,共4页 Transactions of The China Welding Institution
基金 20 0 2年霍英东青年教师科研基金资助项目
关键词 强度匹配 核容器用钢 焊接接头 断裂行为 焊接热影响区 strength mis matching fracture behavior welding heat affected zone welded joint
  • 相关文献

参考文献8

  • 1Minami F, Ohata M, Toyoda M. Determination of required toughness of materials considering transferability to fracture performance evaluation for structure components [J].Journal Society of Naval Architects of Japan,1997, 182(2):647~657.
  • 2Minami F, Ohata M, Toyoda M. Fracture toughness requirement for fracture performance evaluation of welded joints based on the local approach [C]. In: Proc. 15th. Conf. OMAE Florence. 1996, New York: ASME, 1996.193~132.
  • 3Minami F, Hada S. Analysis of strength Mis-matching of welds on fracture performance of welded joints [C].IIW Doc. X-1254-92.
  • 4Tang W, Shi Y W. Influence of strength matching and crack depthon fracture parameters of welded joints[A].Mis-matching of Welds[C].Mechanical Engineering Publication Limited,London,1994.433~443.
  • 5马维甸 张式程 等.低匹配焊接接头不均匀裂纹体的J积分研究[J].焊接学报,1987,8(2):89-96.
  • 6霍立兴.某些制造因素对构件强度的影响[J].焊接学报,1988,9(1):51-58.
  • 7陈丙森,马维甸,苏毅.硬夹层中含有垂直裂纹的焊接接头的断裂参量研究[J].焊接学报,1989,10(3):200-207. 被引量:6
  • 8佐藤邦彦.溶接结构要览[M].东京:黑目出版社,1988.46~63.

二级参考文献5

  • 1马维甸,第五届全国断裂学术会议论文集,1988年
  • 2马维甸,焊接学报,1987年,8卷,2期,89页
  • 3马维甸,机械工程学报,1987年,23卷,4期,43页
  • 4马维甸,机械强度,1987年,9卷,4期,62页
  • 5马维甸,焊接学报,1986年,7卷,1期,23页

共引文献10

同被引文献73

引证文献9

二级引证文献98

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部