摘要
选用水稻开花期耐高温能力强的品种,是缓解极端自然高温导致大幅减产的有效途径之一。为改进水稻品种耐高温性的鉴定技术,2013年和2014年以4个杂交水稻品种为材料,用钵栽方法,分别在开花前后不同时间将钵栽水稻移至人工气候室38.0℃高温下处理5 h,以室外常温(穗层日最高气温31.2~32.8℃)处理为对照,研究极端高温时段对结实率的影响。2015年和2016年以40个杂交中稻组合为材料进行5个分期播种试验,于水稻穗层温度达35℃以上时期,从5个播种期中选择20个同期开始抽穗、生长整齐的稻穗挂牌标记,观察不同时段开花比例,以研究品种间开花期耐高温能力与不同时间开花比例关系。结果表明,杂交水稻开花期高温下11:30前的开花比例、常温下12:00前开花比例分别与耐高温指数呈极显著正相关关系,耐高温品种主要通过提高高温下的结实率而间接增强其耐高温指数,而高温下的结实率则直接影响耐高温指数。高温下开花早的品种在常温下开花也早,杂交水稻开花时间主要集中在9:30—12:30,品种间在不同时刻开花的比例各异。开花后2 h遇高温对结实率影响不明显;穗层气温34℃、35℃且频率达80%以上的最早出现时间分别在13:30和15:30,选择日最高温度≥34℃或35℃出现前2 h开花比例高的品种,能有效地避开高温伤害。基于以上分析分别建立了利用开花期高温下11:30前开花比例、常温下12:00前开花比例和高温下结实率3个指标预测鉴定耐高温指数回归模型,准确率(预测值/实测值)高达92.29%~102.73%。为水稻品种开花期耐高温性鉴定提供了科学适用的新方法。
Using cultivars with high temperature resistance is an effectively approach to reduce yield loss induced by extreme high temperature.The objective of this study was to improve the identification method for high temperature resistance of hybrid rice varieties in both pot and field experiments.To that end,a pot experiment was conducted in an intelligent artificial climate chamber to determine the effects of extreme high temperature(38℃)on percentage grain filling at grain-filling stage in2013and2014.Four cultivars were planted and exposed to extreme high temperature for5hours at5.0hours before and during flowering stage,and1.0hour,1.5hours and2hours after flowering stage.Also concurrently,hybrid rice cultivars were grown under normal background conditions(daily maximum temperature of panicle layer of approximately31.2?32.8℃)as control(CK).A field experiment was conducted using40hybrid rice cultivars to study the relationship between high temperature resistance and flowering rate of hybrid rice at different times of the days based on5sowing dates(March5,March25,April20,May4and May24)in2015?2016.In each year,20cultivars with same heading date were selected from5sowing dates to observe flowering rate at different times of the day.The results showed a significantly positive linear correlation between high temperature resistance index and flowering rate of hybrid rice before11:30AM under high temperature condition or before12:00noon under normal temperature condition.The increase in seed setting rate of high temperature resistant variety under high temperature condition was indirectly related with high temperature resistance index,while its'seed setting rate under high temperature condition was directly related with high temperature resistance index.Flowering of hybrid rice occurred earlier under high temperature condition,the cultivar flowering was also earlier under normal temperature condition.Flowering of hybrid rice was mainly concentrated around9:30AM to12:30PM.However,flowering rate differed with cultivar at different times of the day.Seed setting rate was not significantly affected by high temperature after2hours of flowering.When panicle layer temperature was34℃and35℃,and their frequency reached80%at13:30PM and at15:30PM,respectively,choosing cultivars that flowered2hours before high temperature(daily maximum temperature greater than34℃or at about35℃)could effectively resist high temperature injury.Regression equation was established based on flowering rate before11:30AM under high temperature and before12:00noon under normal temperature condition and seed setting rate under high temperature condition.The equation provided a new identification method of high temperature resistance of hybrid rice cultivars at flowering stage at a percent accuracy(estimated value/measured value)of up to92.29%?102.73%.
作者
徐富贤
周兴兵
蒋鹏
张林
熊洪
郭晓艺
朱永川
刘茂
XU Fuxian;ZHOU Xingbing;JIANG Peng;ZHANG Lin;XIONG Hong;GUO Xiaoyi;ZHU Yongchuan;LIU Mao(Institute of Rice and Sorghum Research, Sichuan Academy of Agricultural Sciences/Key Laboratory of Southwest Rice Biology and Genetic Breeding, Ministry of Agriculture, Deyang 618000, China)
出处
《中国生态农业学报》
CSCD
北大核心
2017年第9期1335-1344,共10页
Chinese Journal of Eco-Agriculture
基金
国家现代农业产业技术体系建设专项(CARS-01-29)
国家公益性行业(农业)专项(20120302)
国家粮食丰产科技工程(2013BAD07B13-05)
四川省财政基因工程项目资助~~
关键词
杂交水稻
高温胁迫
开花时刻
开花比例
结实率
耐高温指数
鉴定方法
Hybrid rice
High temperature stress
Flowering time
Flowering ratio
Seed setting rate
High temperature resistance index
Identification method