摘要
运用ANSYS静力分析模块对塑封电机定子端盖过盈接触进行分析研究,采用可编辑的参数化设计通过拉拔力和材料的屈服强度来确定最优的端盖定子过盈量的取值范围,最终结合工程实践要求确定定子端盖过盈尺寸。塑封电机定子端盖最后通过拉拔力与压装试验表明文章运用的可编辑的参数化的定子端盖过盈接触的分析研究方法切实可行的,可以满足工程化生产的要求。
The interference between stator and the end cover of plastic seal motor is analyzed by ANSYS static analysis module.The optimal design of the end cover and interference range between stator and stator is determined by drawing force and yield strength of the material by editable parameterized design.Finally,the interference size between stator and the end cover is determined by engineering practice.Finally,the drawing force and assembly test of stator and end cover of plastic seal motor show that the analysis of interference of the editable parameterized stator and end cover in this article is feasible and can meet the requirements of engineering production.
出处
《日用电器》
2018年第11期49-54,共6页
ELECTRICAL APPLIANCES
关键词
ANSYS
塑封电机
参数化
过盈量
ANSYS
plastic seal motor
parameter set
interference mount
