摘要
针对树脂基纤维增强复合材料自动铺丝过程中出现的纤维褶皱、分层等工艺缺陷,着重探讨不同轨迹设计方法(固定角、测地线、变曲率)在抑制工艺缺陷上的优劣。对不同轨迹规划方法进行了比较,最终给出针对不同曲面特征、不同铺丝工艺要求的轨迹设计方法。
During the process of automatic fiber placement,aiming at the technological defects such as fiber folding and delamination in laying of resin-based fiber reinforced composites,this paper emphasizes on the advantages and disadvantages of different trajectory design methods(fixed angle,geodesic line,variable curvature)in technological defects.The different trajectory planning methods are compared.Finally,a trajectory design method for different surface characteristics and different wire laying process requirements is given.
作者
王显峰
刘卫平
梁文萍
居相文
肖军
WANG Xianfeng;LIU Weiping;LIANG Wenping;JU Xiangwen;XIAO Jun(School of Materials Science and Technology,Nanjing University of Aeronautics and Astronautics,Nanjing 210016,China;Commercial Aircraft Corporation of China,Ltd.,Shanghai 200210,China)
出处
《航空制造技术》
2019年第4期79-86,共8页
Aeronautical Manufacturing Technology
基金
国家重点基础研究发展计划(973计划)(2014CB046501)
院高校联合创新基金(F19171246)
关键词
复合材料
铺丝工艺
轨迹设计
抑制缺陷
Composite material
Fiber placement process
Trajectory design
Defect Supperession