摘要
为了满足轨道扣件动态检测的需求,设计了一种轨道扣件检测系统,包括照明系统、摄像系统等并通过悬挂系统安装在转向架构架前端;通过关键设备参数的选型计算,设计了安装结构然后校核悬挂系统的螺栓强度,验证其螺栓连接的可靠性;并对整体结构采用ANSYS Workbench有限元分析以及实验室验证,系统符合要求,满足线路的检测需要。
In order to meet the requirements of rail fastener dynamic detection,we design a track fastener inspection system,including lighting system,camera system and installed on the bogie frame through the suspension system such as the front end.According to the model selection calculation of key equipment parameters,the installation structure is designed and the bolt strength of the suspension system is checked to verify the reliability of the bolt connection.ANSYS Workbench finite element analysis and laboratory verification were carried out for the overall vehicle structure.The system met the requirements and met the detection needs of the line.
作者
李欢
柴晓冬
彭乐乐
陈兴杰
Li Huan;Chai Xiaodong;Peng Lele;Cheng Xingjie(School of Urban Rail Transportation,Shanghai University of Engineering Science,Shanghai 201620,China)
出处
《计算机测量与控制》
2019年第2期43-46,64,共5页
Computer Measurement &Control
基金
国家自然科学基金资助项目(51478258)
上海市科委重点支撑项目(18030501300)
上海工程技术大学研究生科研创新项目(E309031701120)
关键词
扣件检测系统
系统选型
结构设计
静力学分析
fastener detection system
system selection
structure design
static analysis
