期刊文献+

Effect of heat treatment on cyclic deformation properties of Fe-26Mn-10AI-C steel 被引量:3

原文传递
导出
摘要 Fully reversed tensile-compression low-cycle fatigue tests were performed at room temperature under strain amplitude of 0.4%.The monotonic tensile results show that Fe-26Mn-10A1-C steels are fully austenite and(he optimal combination of ultimate tensile strength and total elongation was present at 950°C with 65 GPa%.The fatigue results show that the specimen at 1050°C has the maximum fatigue life of 162,000 cycles,which is much longer than twinning-induced plasticity(TWIP)steels of the same strain amplitude.The hot-forging specimen shows high similarity with TWIP steels with rapid initial cyclic hardening followed by cyclic softening and cyclic saturation.After solution heat treatment,it is noteworthy that,after rapid initial cyclic softening,another rapid cyclic hardening and a following decrease with fluctuation were observed at 1000°C.It is reas on able to believe that it is caused by K-carbides precipitated during cyclic deformation.Anolher interesting phenomenon is cyclic stress subsidence observed at 1050°C during its saturation stage at the last quarter of the fatigue life,and the span is about 12.5%of whole fatigue life.
出处 《Journal of Iron and Steel Research International》 SCIE EI CAS CSCD 2019年第2期200-210,共11页
  • 相关文献

同被引文献35

引证文献3

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部