摘要
本文针对转缸活塞压缩机的转轴精加工,提出切实可行的成形磨削方案,并对该工艺方案的控制要点进行分析、说明。
Aiming at the finishing of the rotating shaft of the rotary piston compressor,a feasible forming grinding scheme is proposed,and the control points of the scheme are analyzed and explained.
作者
郭霜
杜忠诚
许甲岿
丁宁
Guo Shuang;Du Zhongcheng;Xu Jiakui;Ding Ning(State Key Laboratory of Air-conditioning Equipment and System Energy Conservation,Zhuhai,Guangdong 519070;Gree Electric Appliances,Zhuhai,Guangdong 519070)
出处
《工程技术研究》
2019年第2期38-39,共2页
Engineering and Technological Research
关键词
转缸活塞
压缩机
转轴
扁位:成形磨削
rotary cyinder piston
compressor
rotary shaft
flat position
form grinding
