1Mascia. C. Reduction of Work Roll Wear by Controlling Tertiary Scale Gruwth[J]. Iron and Steel Engineer, 1998(6) :48.
2Fukagawa T, Okada H, Maehara Y. Mechanism of red scale defect formation in Si-added hot-rolled steel sheets[J]. ISIJ International, 1994,34(3) :906 -911.
3Okada H, Fukagawa T, Ishihara H, et al. Prevention of red scale formation during hot rolling of steels [J]. ISIJ International, 1995,35(12) : 886 - 891.
4Sun W, Tieu A, Jiang Z, et al. High temperature oxide scale characteristics of low carbon steel in hot rolling [ J ]. Journal of Materials Processing Technology, 2004,155(2) : 1307-1312.
5Kiau T, Nagataki Y, Inazumi T, et al. Effects of chemical composition and oxidation temperature on the adhesion of scale in plain carbon steels[J]. ISIJ International, 2001,41 (12) : 1494 - 1501.
6Singh R. Characterization of ‘rolled-in', ‘fragmented' and ‘red' scale formation during secondary processing of steels [J ]. Engineering Failure Analysis, 2006, 13 ( 3 ) : 1044 - 1050.
7Chen R, Yuen W. Review of the high-temperature oxidation of iron and carbon steels in air or oxygen[J]. Oxidation of Metals, 2003,59(4):433-468.
8Zhao B, Vanka S, Thomas B. Numerical study of flow and heat transfer in a molten flux layer[J]. Surface & Coatings Technology, 2005,2(4) :105 - 118.
