期刊文献+

某随动系统执行电机冲击载荷强度分析与验证

Analysis and Verification of the Impact Load Strength of a Certain Servo System Executing Motor
下载PDF
导出
摘要 随动系统作为火炮的重要组成部件,其中执行电机结构强度对火炮性能有很大影响。为满足执行电机冲击载荷强度要求,以某随动系统执行电机为对象,建立有限元模型,通过有限元分析计算发现,执行电机设计结构强度有一定余量。通过冲击试验验证,执行电机状态完好,电气性能工作正常,达到某随动系统的设计要求。该研究结果为执行电机结构和电气性能进一步优化设计提供了仿真分析和试验支撑。 The servo system is an important component of the artillery,in which the structural strength of the executive motor has a great influence on the performance of the artillery.In order to meet the requirement of the impact load strength of the executive motor,with a servo system of executive motor as the object,a finite element model was established.Through the finite element analysis and calculation,it is found that there is a certain margin of the structural strength of the executive motor.The impact test verifies that the electrical performance of the executive motor is in good condition and works normally,which meets the design requirements of the servo system.The research results provide simulation analysis and experimental support for further optimized design of motor structure and electrical performance.
作者 杨军 郭晶 宁变芳 赵昕 刘攀玲 刘妙 YANG Jun;GUO Jing;NING Bianfang;ZHAO Xin;LIU Panling;LIU Miao(Northwest Institute of Mechanical & Electrical Engineering,Xianyang 712099,Shaanxi,China)
出处 《火炮发射与控制学报》 北大核心 2019年第2期62-65,共4页 Journal of Gun Launch & Control
关键词 随动系统 执行电机 冲击载荷 分析与验证 servo system motor shock load analysis and verification
  • 相关文献

参考文献3

二级参考文献16

  • 1傅建林,荣见华,杨振兴.带有预应力的连续体组合结构拓扑优化[J].应用力学学报,2005,22(2):231-236. 被引量:6
  • 2王继强,王凤翔,鲍文博,关恩录.高速永磁电机转子设计与强度分析[J].中国电机工程学报,2005,25(15):140-145. 被引量:96
  • 3韩则胤.内嵌式转子无刷直流电机驱动系统在汽车电动空调中的应用研究[D].杭州:浙江大学电气工程学院,2009:61-94.
  • 4Kim Y K, Lee J. A comparative study of high-speed permanent magnet synchronous motor for air compressor [ C ]//in INTMAG, 2005:663-664.
  • 5Ha K H, Hong J P, Kim G T, et al. Mechanical Vibration and Stress Analysis of the Link of Interior Permanent Magnet type Synchro- nous Motor[ C ]//Interuational Conference on Electric Machines and Drives, 1999 : 150-152.
  • 6Lovelace E C, Jahns T M, Keim T A, et al. Mechanical design con- siderations for conventionally laminated, High-Speed, Interior PM Synchronous Machine Rotors [ J 1. IEEE Trans. on Industry Appli. , 2004,40 (3) :806-812.
  • 7Lee K J,Kim K C ,Lee J. Bridge optimization of interior permanent magnet motor for hybrid electric vehicle [ C ]//Magnetics Confer- ence. INTERMAG,2003 : GQ-07.
  • 8Lee K J, Kim K C, Lee J. Rotor optimization of interior permanent magnet synchronous motor considering mechanical stress [ C ]// Magnetics Conference. INTERMAG Asia,2005 : 717-718.
  • 9Jun C H. Analysis of the mechanical stresses on a squirrel cage in-duction motor by the finite element method[ J]. IEEE Transactions on Magnetics, 1999,35( 1 ) :1282-1285.
  • 10闻邦椿.机械设计手册[M].北京:机械工业出版社,2011.

共引文献34

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部