High Performance SAR ADC with Mismatch Correction Latch and Improved Comparator Clock

We propose a high performance 10-bit 100-MS/s(million samples per second)successive approximation register(SAR)analog-to-digital converter(ADC)with mismatch correction latch and improved comparator clock.Using a high-low supply voltage technology,the bias output impedance of the preamplifier of the comparator is increased.Therefore,the common mode rejection ratio(CMRR)of the comparator is improved,and further diminishing the signal-dependent offset caused by the input common-mode voltage variation.A digital-to-analog converter(DAC)control signal correction latch is proposed to correct the control signal error resulted from process mismatch.The 30-point Monte Carlo mismatch simulated results demonstrate that the minimum spurious-free dynamic range(SFDR)of the ADC is improved by 2 dB with this correction latch.To ensure sufficient high bit switching time of the DAC and sufficient low bit comparison time of the comparator,a data selector used in the comparator clock is presented.The optimized time distribution improves the performance of the SAR ADC.This prototype was fabricated using a one-poly-eight-metal(1 P8 M)55 nm complementary metal oxide semiconductor(CMOS)technology.With measured results at 1.3 V/1.5 V supply and 100-MS/s,the ADC achieves a signalto-noise and distortion ratio(SNDR)of 59.4 dB and consumes 2.1 mW,resulting in a figure of merit(FOM)of31 fJ/conversion-step.In addition,the active area of the ADC is 0.018 8 mm2.