摘要
以化学污泥为原料制备非烧结砖,探究了5种不同添加剂及其添加量对非烧结污泥砖抗压强度的影响。结果显示,最佳添加剂为PVA胶,其次为水玻璃和抗裂纤维,砂子和糯米胶的效果较差。当PVA胶添加量为1.5%时,抗压强度达到最大,为10.2MPa,24h吸水后的抗压强度为5.9MPa。
The non-sintered bricks were prepared using the chemical sludge as raw materials, and the effects of five different additives and their contents on the compressive strength of non-sintered sludge bricks were investigated. The results showed that the best additive is PVA glue, followed by water glass and anti-cracking fiber, and the effects of sand and glutinous rice glue is poor. When the amount of PVA glue was 1.5%, the compressive strength reached a maximum of 10.2 MPa, and the compressive strength after 24 hours of water absorption was 5.9 MPa.
作者
任梓涵
周磊
王荣
刘晗
孟丽
任晓莉
REN Zihan;ZHOU Lei;WANG Rong;LIU Han;MENG Li;REN Xiaoli(Department of Environment and Safety Engineering, Taiyuan Institute of Technology, Taiyuan Shanxi 030008, China)
出处
《山西化工》
2019年第4期4-6,共3页
Shanxi Chemical Industry
基金
2019年山西省高等学校大学生创新创业训练计划项目(重点)资助(项目编号2019619)
关键词
污泥
非烧结砖
制备
抗压强度
sludge
non-fired brick
preparation
compressive strength