期刊文献+

有机材料EnBOD的放大自发发射性能研究 被引量:2

Study on Amplified Spontaneous Emission Properties of En BOD Material
下载PDF
导出
摘要 在紫外脉冲激光泵浦条件下,研究了有机材料En BOD的放大自发发射(ASE)性能。En BOD的甲苯稀溶液样品具有较窄的吸收和荧光光谱,主峰分别位于508 nm和527 nm。其ASE效率随着溶液浓度而变化,浓度为0.008 mol·L-1的En BOD样品具有最高的ASE效率,达到22.6%。其ASE主峰位于542 nm,阈值约为29.5 k W·cm-2。阈值后的ASE半宽约为12.4 nm。经紫外脉冲激光20万次泵浦后,ASE的光强衰减为初始强度的61.2%。结果表明En BOD是一种ASE阈值较低、光稳定性良好的激光材料。 Amplified spontaneous emission( ASE) properties of organic material En BOD were studied under ultraviolet pulse laser pumping. En BOD sample in dilute toluene solution shows narrowband absorption and PL spectra,with the maximum peak located at 508 nm and 527 nm,respectively.The ASE efficiency changes with the solution concentration. The maximum ASE efficiency of 22. 6%was obtained when the En BOD sample concentration is 0. 008 mol·L- 1,in which the ASE threshold is 29. 5 k W·cm- 2,ASE peak is 542 nm and full width at half maximum is about 12. 4 nm.The ASE output intensity attenuated to 61. 2% of the initial strength under the pulse pump frequency of 200 000. The results indicated that En BOD is a kind of laser material with low ASE threshold and good light stability.
出处 《发光学报》 EI CAS CSCD 北大核心 2015年第6期661-665,共5页 Chinese Journal of Luminescence
基金 国家自然科学基金(51102228) 内蒙古自然科学基金博士基金(2014BS0205) 内蒙古民族大学博士科研启动基金(BS311)资助项目
关键词 有机材料 放大自发发射 光稳定性 organic material amplified spontaneous emission photostability
  • 相关文献

参考文献3

二级参考文献22

  • 1Li J,Kim S,Edington S. A study of stabilization of P3HT/PCBM organic solar cells by photochemical active TiOx layer[J].Solar Energy Materials & Solar Cells,2011,(04):1123-1130.
  • 2Shaheen S E,Brabec C J,Sariciftci N S. 2 5% efficient organic plastic solar cells[J].Applied Physics Letters,2001,(06):841-843.
  • 3Jeon S O,Lee J Y. Improved high temperature stability of organic solar cells using a phosphine oxide type cathode modification layer[J].Solar Energy Materials & Solar Cells,2011,(04):1102-1106.
  • 4Sun K,Xia Y,Ouyang J. Improvement in the photovoltaic efficiency of polymer solar cells by treating the poly (3,4-ethylenedioxythiophene):Poly (styrenesulfonate) buffer layer with co-solvents of hydrophilic organic solvents and hydrophobic 1,2-dichlorobenzene[J].Solar Energy Materials & Solar Cells,2012,(01):89-96.
  • 5Sefanc M A,Okyay A K,Demir H V. Plasmonic backcontact grating for P3HT/PCBM organic solar cells enabling strong optical absorption increased in all polarizations[J].Optics Express,2011,(15):14200-14209.
  • 6Vak D,Kim S S,Jo J. Fabrication of organic bulk heterojunction solar cells by a spray deposition method for lowcost power generation[J].Applied Physics Letters,2007,(08):081102-0811-3.
  • 7Zhou Y,Cheun H,Choi S. Optimization of a polymer top electrode for inverted semitransparent organic solar cells[J].ORGANIC ELECTRONICS,2011,(05):827-831.
  • 8Weickert J,Sun H,Palumbiny C. Spray-deposited PEDOT:PSS for inverted organic solar cells[J].Solar Energy Materials & Solar Cells,2010,(12):2371-2374.
  • 9Kopola P,Zimmermann B,Filipovic A. Aerosol jet printed grid for ITO-free inverted organic solar cells[J].Solar Energy Materials & Solar Cells,2012.252-258.
  • 10Kim K J,Kim Y S,Kang W S. Inspection of substrate-heated modified PEDOT:PSS morphology for all spray deposited organic photovoltaics[J].Solar Energy Materials & Solar Cells,2010,(07):1303-1306.

共引文献6

同被引文献11

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部