期刊文献+

云南省火电厂氮氧化物排放现状及分析 被引量:1

Analysis of the NO_x Emission Status of Thermal Power Plants in Yunnan
下载PDF
导出
摘要 经济增长带来的能源消耗使得火电厂排放了越来越多的氮氧化物,国家对环保的重视出台了更为严格的大气污染物排放标准GB 13223-2011。文章首先介绍了云南全省氮氧化物排放情况和趋势,概述了云南各火电厂氮氧化物排放现状及采取措施,然后根据不同的锅炉类型分别对常规煤粉炉、W形火焰炉及CFB炉机组进行脱硝改造分析,这对找出合理的达标脱硝技术路线、控制烟气污染物具有一定的参考价值。 The emission of NOxfrom thermal power plant increased due to the economy and energy consumption growed,the stricter atmospheric pollutants standard GB1322-2011 was issued by the government. The status and trend of NOxemission in Yunnan province was introduced in this article, the NOxemission status and control measures of thermal power plant were summarized, the denitration transformation of pulverized coal boiler, W-shaped flame boiler and CFB boiler were analysised. This result was valuable to find out reasonable denitration technology solutions and control measures of reducing gas pollutants.
出处 《环境科学与技术》 CAS CSCD 北大核心 2014年第S2期471-474,共4页 Environmental Science & Technology
关键词 火电厂 氮氧化物 大气污染物 云南 thermal power plant NOx atmospheric pollutants Yunnan
  • 相关文献

参考文献9

二级参考文献32

  • 1吕清刚,雍玉梅,那永洁,包绍麟,孙运凯,贺军,矫维红,高鸣.循环流化床燃煤锅炉的SO_2和NO_x排放的试验和数值计算[J].中国电机工程学报,2005,25(1):142-146. 被引量:42
  • 2包绍麟,吕清刚,那永洁,孙运凯,苏小平,张俊龙,王树恩.480t/h循环流化床锅炉燃烧运行调整[J].江苏锅炉,2006(3):17-18. 被引量:1
  • 3吴阿峰,李明伟,黄涛,谭灿燊.烟气脱硝技术及其技术经济分析[J].中国电力,2006,39(11):71-75. 被引量:36
  • 4白少林.在役低挥发分煤锅炉燃烧制粉系统运行技术评估报告[R].国电热工研究院,2002.
  • 5魏铜生,等.黔北电厂2号锅炉制粉燃烧系统调整试验报告[R].西安热工研究院有限公司,2006.
  • 6许传凯,等.低挥发分煤的燃烧与W火焰锅炉专题研讨会论文集[C].中国电机工程学会,2001.
  • 7魏铜生,等.阳城电厂6号锅炉燃烧优化调整试验报告[R].西安热工研究院有限公司,2006.
  • 8Tsuji H. High Temperature Air Combustion [ M ]. Boca Raton, FL:CRC Press,2003.
  • 9Gupta A K. Flame Characteristics with High Temperature Air Combustion [ C ]. Reno: 38^th Aerospace sciences meeting and exhibit,2000.1-10.
  • 10Gyung-Min Choi, Masashi Katsuki. Advanced low NOx combustion using highly preheated air [ J ]. Energy Conversion and Management, 2001,42 (5) :639-652.

共引文献127

同被引文献17

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部