期刊文献+

季铵化聚芳吲哚阴离子膜的制备 被引量:1

Preparation of quaternized poly (aryl indole) anion exchange membrane
下载PDF
导出
摘要 通过吲哚2,3二酮和联苯在超强酸催化下反应,合成了不含芳基醚键的聚芳吲哚聚合物,而后通过酰胺与2,3环氧丙基三甲基氯化铵反应,成功制备了一种新的季铵化聚芳吲哚阴离子交换膜.由于不含芳基醚键,有效减弱了OH-对膜主链骨架的攻击,提高了膜的耐碱性.膜浸泡在80℃的1 mol/L KOH水溶液中672 h后,其离子电导率和离子交换容量分别达到测试前的84%和89%,证明其具有良好的耐碱性.将该膜制备成膜电极,在80℃下测试单电池性能,开路电压为0.97 V,在电流密度为150 mA/cm^2时最大功率密度达到68 mW/cm^2. The poly(aryl indole)polymers without aryl ether bond were synthesized through indole-2,3-dione and biphenyl by super acid catalyzed,and then followed the reaction by the amide with 2,3-epoxypropyl trimethyl ammonium chloride.A novel quaternized poly(aryl indole)anion exchange membrane was successfully prepared.Since the aryl ether bond was absent,it was effectively reduced that the attack on the main chain skeleton of the membrane from hydroxide,improving the alkali resistance of the membrane.Moreover,after immersed in the 1 mol/L KOH aqueous solution for 672 h at 80℃,ionic conductivity and ion exchange capacity of the PBN 72GA membrane has reached 84%and 89%of initial value,respectively.This proved the membrane had good alkali resistance.Moreover,the membrane electrode assembly was prepared by the membrane and the performance of the fuel cell was tested at 80℃.The fuel cell established the open circuit voltage of 0.97 V and the maximum power density was up to 68 mW/cm^2 when the current density was 150 mA/cm^2.
作者 王凯锋 焉晓明 贺高红 WANG Kaifeng;YAN Xiaoming;HE Gaohong(School of Petroleum and Chemical Engineering,Dalian University of Technology,Panjin 124221,China)
出处 《膜科学与技术》 CAS CSCD 北大核心 2019年第4期15-20,28,共7页 Membrane Science and Technology
基金 国家自然科学基金联合基金项目(U1663223)
关键词 无芳基醚 聚芳吲哚 耐碱性 阴离子交换膜 aryl ether-free poly(aryl indole) alkali resistance anion exchange membrane
  • 相关文献

参考文献2

二级参考文献37

  • 1Varcoe J R, Slade R C T. Prospects for alkaline anion- exchange membranes in low temperature fuel cells[J]. Fuel Cells 2005, 5.187--200.
  • 2Wu Y H, Wu C M, Xu T W,et al. Novel silica/ poly (2, 6-dimethyl-1, 4-phenylene oxide) hybrid anion ex- change membranes for alkaline fuel cells= effect of heat treatment[J]. J Membr Sci, 2009, 338: 51--60.
  • 3Wu Y H, Wu C M, Xu T W, et al. Novel silica/poly (2, 6-dimethyl-1,4-phenylene oxide) hybrid anion-ex- change membranes for alkaline fuel cells:Effect of silica content and the single cell performance [J]. J Power Sources, 2010, 195:3069--3076.
  • 4Varcoe J R, Slade R C T, Yee E L H. An alkaline poly- mer electrochemical interface: A breakthrough in appli- cation of alkaline anion-exchange membranes in fuel cells [J]. Chem Commun, 2006;1428--1429.
  • 5Varcoe J R, Beillard M, Halepoto D M, et al. Mem- brane and electrode materials for alkaline membrane fuel cells[J]. Electrochem Soc Trans, 2008, 16: 1819-1834.
  • 6Varcoe J R, Slade R C T. An electron-beam-grafted ETFE alkaline anion-exchange membrane in metal-cat- ion-free solid-state alkaline fuel cells [J]. Electrochem Commun, 2006,8 : 839--843.
  • 7Xu T W, Yang W H. Fundamental studies of a new se- ries of anion exchange membranes: membrane prepara- tion and characterization[J]. J Membr Sci, 2001, 190: 159--166.
  • 8Varcoe J R, Slade R C T, Wright G L,et al. Steady- state d0 and impedance investigations of H2/02 alkaline membrane fuel cells with commercial Pt/C, Ag/C, and Au/C cathodes[J]. J Phys Chem B, 2006, 110:21041--21049.
  • 9Xu T W, Fu R Q, Yang W H, et al, Fundamental studies on a novel series of bipolar membranes pre- pared from poly (2, 6-dimethyl-1, 4-phenylene oxide) (PPO) (Ⅱ). Effect of functional group type of anion- exchange layers on I-V curves of bipolar membranes [J]. J Membr Sci, 2006, 279:282--290.
  • 10Chen J H, Asano M, Yamaki T, etal. Preparation and characterization of chemically stable polymer electro- lyte membranes by radiation-induced graft copolymeri- zatlon of four monomers into ETFE films[J]. J Membr Sci, 2006, 269.194--204.

共引文献21

同被引文献6

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部