期刊文献+

太阳能烟囱发电系统中叶片偏置方向对启动流速的影响

The Influence of Blade of Offset Direction on Starting Velocity in The Solar Chimney power System
下载PDF
导出
摘要 在太阳能烟囱发电系统中,叶轮叶片的偏置方向对发电机的最小启动流速是有影响的.通过对烟囱的流体域的分析,确定流体的流动状态,利用流体的动量方程进行理论分析,通过数学计算得到最佳的叶片斜率.把计算出来的曲线斜率输入到Creo中进行风机叶片的曲面建模,将叶片模型在ANSYS中进行CFD仿真,输出叶片表面的压力值,并将叶片的压力值进行统计分析.经分析得到以下结论,向下偏置的叶片受到的压力随着偏置角度的增加,压力逐渐增大,即在相同的烟囱直径下,向下偏置的叶片有更低的启动流速. In the solar chimney power system,the offset direction of the impeller blade has an effect on the minimum starting velocity of the generator.The flow state of the fluid is determined by analyzing the fluid domain of the chimney.The momentum equation of the fluid is used for theoretical analysis,and the optimal blade slope is obtained through mathematical calculation.The slope of the calculated curve was put into Creo for the curved surface modeling of the fan blade,and the blade model was simulated by CFD in ANSYS to output the pressure value of the blade surface,and the pressure value of the blade was statistically analyzed.It is concluded that the pressure on the downward biased blade increases with the increase of the bias Angle,which means that under the same chimney diameter,downward biased blades have a lower starting velocity.
作者 刘佳 田瑞 许肖飞 聂晶 LIU Jia;TIAN Rui;XU Xiao-fei;NIE Jing(College of Aviation,Inner Mongolia University of Technology,Hohhot 010051,China;College of Energy and Power Engineering,Inner Mongolia University of Technology,Hohhot 010051,China)
出处 《内蒙古工业大学学报(自然科学版)》 2019年第3期188-193,共6页 Journal of Inner Mongolia University of Technology:Natural Science Edition
基金 内蒙古工业大学博士基金项目(BS201933)
关键词 太阳能发电 风机叶片 叶片偏置 降低启动流速 Solar Power fan blade blade offset reduced starting velocity
  • 相关文献

参考文献5

二级参考文献46

  • 1杨世铭.传热学[M].高等教育出版社,1987,10..
  • 2Shayler P J,Tinwell P,Dixon J,et al.Optimisation of Factors to Reduce Cold-Start Emissions Using Taguchi Methods[M].USA:USA Mechanical Engineering Publications,1993:21-27.
  • 3Bates M C,Heikal M R.A Parametric Inlet Port Design Tool for Multi-Valve Diesel Engines[R].IMechE Paper C6069/001/2002,2002.
  • 4Ghauri A,Richardson S H,Nightingale C J E.Variation of Both Symmetric & Asymmetric Valve Events on a 4-Calve SI Engine and the Effect on Emissions & Fuel Economy[M].USA:Society of Automotive Engineers Special Publication,2003:57-62.
  • 5Flint S,Cawsey P.Use of Experimental Design and Two Stage Modelling in Calibration Generation for Variable Camshaft Timing Engines[M].Germany:Expert Verlag,2003:44-49.
  • 6Mark Guerrier,Paul Cawsey.The Development of Model Based Methodologies for Gasoline IC Engine Calibration[C].SAE Paper 2004-01-1466,2004.
  • 7Knaak M,Schoop U,Barzantny B.Dynamic Modeling and Optimization--The Natural Extension to Classical DoE[A].Dr-lng Karsten Ropke Design of Experiments (DoE) in Engine Development Ⅲ[C].Germany:Expert Verlng,2007:93-96.
  • 8Dr Karsten Roepke.DoE-Design of Experiments-Methoden und Anwendungen in der Motorentwicklung[M].Germany:Verlag Modeme Industrie,2005:219-223.
  • 9Habchi C,Verboeven D,Huynh Huu C,et al.Modeling Atomization and Break-up in High Pressure Diesel Sprays[C].SAE Paper 970881,1997.
  • 10Sushma Y,Sridhar M,Dharmadhikari A D.Experiments Planning for Robust Design Through CAE[C].SAE Paper 2006-01-3518,2006.

共引文献86

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部