3KENMOCHI K, YARITA I, ABE H et al. Effect of micro-defects on the surface brightness of cold-rolled stainless-steel strip[J]. Journal of Materials Processing Technology, 1997, 69(1-3): 106-111.
4DICK K, LENARD J G. The effect of roll roughness and lubricant viscosity on the loads on the mill during cold rolling of steel strips[J]. Journal of Materials Processing Technology, 2005, 168(1). 16-24.
5LE H R, SUTCLIFFE M P F. Analysis of surface roughness of cold-rolled aluminium foil[J]. Wear, 2000, 244(1-2): 71-78.
6LENARD J G. The effect of roll roughness on the rolling parameters during cold rolling of an aluminium alloy[J]. Journal of Materials Processing Technology, 2004, 152(2): 144-153.
7MA B, TIEU A K, LU C, et al. An experimental investigation of steel surface characteristic transfer by cold rolling[J]. Journal of Materials Processing Technology, 2002, 125-126: 657-663.
8KIJIMA H, BAY N. Influence of tool roughness and lubrication on contact conditions in skin-pass rolling[J]. Journal of Materials Processing Technology, 2009, 209(10): 4835-4841.
9WANG Zhrgang, DOHDA K, HARUYAMA Y. Effects of entraining velocity of lubricant and sliding velocity on friction behavior in stainless steel sheet rolling[J]. Wear, 2006, 260(3): 249-257.
10AHMED R, SUTCLIFFE M P F. Identification of surface features on cold-rolled stainless steel strip[J]. Wear, 2000, 244(1-2): 60-70.
