关于2^#勘探试验洞转弯半径500 m是否满足皮带机出渣要求的论证

Demonstrations on Whether the Turning Radius of 2^# Exploration Test Hole 500 m Meets the Slag Requirements of Belt Machine

采用2台TBM进行施工,来论证转弯半径为500 m的勘探试验洞能否满足皮带机出渣需求。经过设计方案复核,2^#勘探试验洞转弯半径为500 m时满足皮带机出渣要求,即设计方案是合理可行的。在实际工程应用中,方案一、方案二皮带机布置均可满足隧洞转弯半径500 m时出渣需求,但各有利弊,施工单位可根据实际情况进行选择。

This paper mainly demonstrates the construction of two TBMs,whether the exploration test hole with turning radius of 500 m can meet the slag requirement of belt machine.Design review,2^# exploration test hole meet belt machine slag requirements when turning radius is 500 m,that the design is reasonable and feasible.In practical engineering applications,scheme I and II belt machine layout can meet the slag requirement when tunnel turning radius is 500 M,but there are pros and cons,the construction unit can choose according to the actual situation.