TS2130深孔钻镗床专用找正装置设计

The Improvement of Deep Hole Machining on Short Product

TS2130深孔钻镗床将工件冒口端装夹在主轴卡盘上,锭尾端装夹在中心架上,但是工件找正时间长。为提高找正效率,设计了专用找正装置。将找正装置一端通过螺纹与刀杆连接,另一端上面放置百分表对短节产品进行找正,将找正工序缩减到3个,将找正时间减少30 min。

TS2130 deep-hole drilling and boring machine clamps the riser end of the workpiece on the spindle chuck and the end of the ingot on the center frame,but it takes a long time to correct the workpiece.In order to improve the alignment efficiency,a special alignment device is designed.One end of the alignment device is connected to the cutter bar by a thread,and a dial indicator is placed on the other end to perform alignment of the short joint products.The alignment process is reduced to three,and the alignment time is reduced by 30 minutes.