摘要
以700℃煅烧锂渣(CLS)为原料制备煅烧锂渣基地质聚合物,研究不同硅铝比、氢氧化钠浓度对锂渣基地质聚合物性能及微观结构的影响。结果表明:当硅铝比为2.9、氢氧化钠浓度为3.5 mol/L时,煅烧锂渣基地质聚合物的强度较高,1、3、7、28 d抗压强度分别为59.0、46.8、57.8、71.3 MPa;煅烧锂渣基地质聚合物的主要产物为N-A-S-H凝胶,体系微观呈片状凝胶层层堆积的密实结构。
In this study,lithium slag-based geopolymer were prepared by calcining lithium slag at 700℃.The effects of different Si/Al ratios and NaOH concentrations on the properties and microstructures of lithium slag-based geopolymer were studied.The results show that while the Si/Al ratio is 2.9,and the concentration of sodium hydroxide is 3.5 mol/L,the base polymer of lithium slag reaches higher strength.It reveals that calcining lithium slag based geopolymer exhibit compressive strength of 59.0 MPa,46.8 MPa,57.8 MPa and 71.3 MPa at 1 d,3 d,7 d and 28 d respectively.The main product of the calcined lithium slag base polymer is N-A-S-H gel,the system microscopically is dense structure of sheet gel layer.
作者
韩乐
刘泽
张延博
王吉祥
谢福助
HAN Le;LIU Ze;ZHANG Yanbo;WANG Jixiang;XIE Fuzhu(Research Institution of Concrete and Eco-Materials,School of Chemical and Environmental Engineering,China University of Mining and Technology-Beijing,Beijing 100083,China)
出处
《新型建筑材料》
北大核心
2020年第6期9-13,共5页
New Building Materials
基金
国家重点研发计划项目(2017YFC 0703203)。
关键词
煅烧锂渣
碱激发
力学性能
微观形貌
红外分析
calcining lithium slag
alkali activation
mechanical properties
microstructure
FTIR analysis
