Cross-sectional deformation of H96 brass double-ridged rectangular tube in rotary draw bending process with different yield criteria

Different yield criterion has great difference in predicting the deformation of tube with different material.In order to improve the prediction accuracy of the cross-sectional deformation of the double-ridged rectangular tube(DRRT)during rotary draw bending(RDB)process,Mises isotropic yield criterion,Hill’48 and Barlat/Lian anisotropic yield criteria commonly used in practical engineering are introduced to simulate RDB of DRRT.The inverse method combining uniaxial tensile test of whole tube and response surface methodology was proposed to identify the parameters of Hill’48 and Barlat/Lian yield criteria of small-sized H96 brass extrusion DRRT as well.Then based on ABAQUS/Explicit platform,the FE models of RDB process of DRRT considering Mises,Hill’48 and Barlat/Lian yield criteria were built.The results show that:The variation trend of cross-sectional deformation ratio is same when using different yield criteria.The cross-sectional deformation ratio by using Mises yield criterion is close to that by using Hill’48 yield criterion.However,there is a quite difference between by using Barlat/Lian yield criterion and by using Mises or Hill’48 yield criteria.The prediction values of cross-sectional height deformation by using three yield criteria all underestimate the experiment ones,and the prediction values of cross-sectional width deformation overestimate the experiment ones.By comparing the simulation results of cross-sectional deformation of the DRRT with different yield criteria and experiment ones,Barlat/Lian yield criterion is found to be suitable for describing the RDB process of DRRT.