摘要
文章从包钢使用乳液浓度、乳液p H值与颗粒度适配性以及皂化值生产过程进行总结,结果表明,当末机架乳液浓度在0.9%~1.1%范围内、乳液p H值在5.8~6.0范围内、乳液皂化值大于160 mg KOH/g时,带钢板面反射率相对较高,残油、残铁含量在合理范围内,带钢表面清洁度较好。
In this paper,the productive process is summarized from the concentration,p H value,granularity fitness and saponification value of emulsion used in Baotou Steel. The results showed that when the emulsion concentration of final stand is within the range of 0. 9% ~ 1. 1%,p H value of emulsion is within the range of 5. 8 ~ 6. 0 and saponification value of emulsion is greater than 160 mg KOH/g,the reflectance of strip surface is relatively higher,contents of residual oil and residual iron are within a reasonable range as well as surface clearness of strip is better.
作者
班胜利
郭瑞华
常慧
Ban Sheng-li;Guo Rui-hua;Chang Hui(CSP Plant of Inner Mongolia Baotou Steel Union Co.,Ltd.,Baotou 014010,Inner Mongolia Autonomous Region,China;School of Materials and Metallurgy,Inner Mongolia University of Science and Technology,Baotou 014010,Inner Mongolia Autonomous Region,China)
出处
《包钢科技》
2020年第3期36-38,共3页
Science & Technology of Baotou Steel
关键词
乳化液浓度
p
H值
皂化值
表面清洁度
emulsion concentration
p H value
saponification value
surface clearness
